Outer Limits 4x4 Board

ok this is the rear end of a nissan patrol safari alternator
what i want to do is take the rear end off (the pump) and use the alt with out it (i don't need it)

so will there be any damage done to it by doing this i know putting some kind of end plat on would be better but is it needed

most of them wont work because the oil feeds through to the back bearing of the alternator.

midi73 wrote:most of them wont work because the oil feeds through to the back bearing of the alternator.

i see can i just cut that shaft off grease that bearing and put a flat plate over the back and silicone around the shaft area to keep the grease in?

Bartso wrote:

midi73 wrote:most of them wont work because the oil feeds through to the back bearing of the alternator.

i see can i just cut that shaft off grease that bearing and put a flat plate over the back and silicone around the shaft area to keep the grease in?

trial and error, wont know untill ya do it