Page 1 of 1
Wiring diagram for central locking tirgger wires
Posted: Tue Oct 31, 2006 1:53 pm
by rot8s
Hi Guys/Girls
Does anyone have a diagram as to where and what colour the positive and negitive triggers for the central locking are as I want to attach a remote system.
Thanks
Posted: Tue Oct 31, 2006 3:36 pm
by Adomw
What model?
Posted: Tue Oct 31, 2006 4:01 pm
by rot8s
sorry,
NJ T D
Posted: Tue Oct 31, 2006 6:23 pm
by TurboPaj
Check through the links in this post man.
http://www.outerlimits4x4.com/viewtopic.php?t=28773
I just added one to the bottom that may have what you're after, although no promises
Posted: Wed Nov 01, 2006 3:15 pm
by glenn_c
I am not sure what the wire colours are but the controller is just above the fuse box. I tapped into the wires there for my central locking.
Regards Glenn
Posted: Wed Nov 01, 2006 3:28 pm
by glenn_c
MITSUBISHI MONTERO 1995-96
WIRE COLORS LOCATION
12 VOLTS CONSTANT WHT IGN HARNESS
IGNITION 1 BLK/WHT IGN HARNESS
IGNITION 2 BLU/RED IGN HARNESS
IGNITION 3
ACCESSORY/HEATER BLOWER 1 BLU/YEL IGN HARNESS
ACCESSORY/HEATER BLOWER 2
STARTER BLU/BLK IGN HARNESS
PARKING LIGHTS GRN/WHT BEHIND DRV SPEAKER @ JCT BLOCK
DOMELIGHT GRN/RED DRV KICK
PWR DOOR LOCK BLK/RED @ CONN BEHIND DRV SPEAKER
PWR DOOR UNLOCK BLK/BLU @ CONN BEHIND DRV SPEAKER (TYPE B)
TRUNK RELEASE
TACH SENSOR WTH AT IGNITER ON REAR OF ENGINE
BRAKE GRN(+) AT SWITCH ON BRAKE PEDAL BRACKET
HORN GRN/BLK STEERING COLM
Posted: Wed Nov 01, 2006 5:29 pm
by Overkill
This should go in the Tech Bible, real helpful for doing remote locking or even for installing an alarm.
Posted: Thu Nov 02, 2006 9:05 am
by rot8s
Thanks Glenn thats great mate, That should go in the tech section.
Thanks Glenn W