Page 1 of 1
EXAUST MANIFOLD ON THE VITARA 1.6 CARBY
Posted: Thu Nov 09, 2006 6:28 pm
by Daniel
CAN I BOLT MY EXTRACTORS OFF MY SUZUKI SIERRA 1.3 STRAIGHT UP TOO MY VITARA 1.6 CARBY MOROR..
IF SO HOW??
IF NOT, WHERE CAN I GET A MANIFOLD FOR MY VITARA 1.6
DAN!
Posted: Thu Nov 09, 2006 7:27 pm
by bazooked
yes u can if its an 8 valve, ya just to heat up the bottom of the extractors and bend them down to clear the body, because the vit motor is taller. and please dont shout we r tryin to sleep.
Posted: Thu Nov 09, 2006 7:37 pm
by nicbeer
Bazooked - Do the EFI ones clear the chassis/body in the sierra.
Nic
Posted: Thu Nov 09, 2006 8:14 pm
by mud4b
nicbeer wrote:Bazooked - Do the EFI ones clear the chassis/body in the sierra.
Nic
no depending on type.
most have duel pipes near the chassis. its the outer pipe that hits on the engine mount/chassis.
to fix this we used to cut the middle section (from 4 into 2)just after the bend and just before the bend (2 into 1 ) then reweld in a new bit of pipe so it sits 1" further back compared to the other pipe..
Posted: Thu Nov 09, 2006 8:57 pm
by bazooked
there is a few different types i got the wrong 1 first but second go was much better, will have a look tomorrow and tell ya the brand u need to get.
Posted: Thu Nov 09, 2006 9:28 pm
by Santos
if you replacing the stock set up can i have it
back to the topic
Posted: Thu Nov 09, 2006 10:53 pm
by Daniel
keeep on track
back to my topic hahaha,
sorry for yelling
so the extractors i have now that were off my 1.3 sierra will fit on to the 1.6 carby 8 valve.
just need to bend the bottom to clear body correct?
Thank you
Dan!