Outer Limits 4x4 Board

Who run`s it through the radiater fins and gets away with it,Thinking that with all the throwing around the rig gets it would pull through or rip off

I've seen cases where the mounts which go through the radiator have rubbed holes in the cores due to wear when moving around.

i brought my car with one mounted like this and hasn't had a problem
i would just check for any leaks etc

My old ford laser was like that from the factory, rubbers on both sides.

mine was mounted with the plastic bolts through the radiator fins. Then when i fitted a larger thermop fan i just cable tied it (it was on the front of the radiator) to the grille. That was heaps easier, quicker and i never had a problem with it

With the one i got it sits a few mill from the radiator,wich i think would be to close?

Au thermo's on an MK radiator mount around the outside
Just made two little aluminium brackets to hold it in place


[/url]

Make a frame using angle 20-25mm , then bolt them to that

Bolting through the cores is disgusting

What is the best distance between the blades on the thermo fan to the core, for the best cooling?
Mine were mounted directly on the radiator but am changing to a shrould and thermo set up.

Bolting through the core will eventually let you down. I had one done like this, rubbers both sides of the core, and lasted for years, but then, on a trip from Karumba to Musgrave, the corregations made it float up and down, eventually wearing through the sides of the fins in 3 places. A pepper and egg repair job about 200+km from anywhere.