I have just about figured out how to rebuild my weber, but I would like to know how to set the float level to 41mm as stated in a few weber topics. I want to prevent the incline problem that weber tend to suffer.
cheers
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
How Do You Set the Float level on a weber 32/36
Hi Jaczook have a good read through the webber thread on this site, also check www.offroad.com posts by sarge. I tried to post some pics but it didnt work. If its an old carb I highly recomend buying a rebuild kit to do at the same time. Its not very hard and if your setting the float you should put a kit in it. It will also give you detailed instructions on how to do it. P.S brass and plastic floats have different settings. Good luck.
Nik
Nik
Who is online
Users browsing this forum: No registered users and 2 guests