Page 1 of 1
NP231 Imfo...........
Posted: Mon Nov 10, 2003 3:04 pm
by Bitsamissin
On a hunch I'm after the internal measurement (diameter) and spline count of an NP231 t/case input gear. I'm pretty sure it's a course 23 spline but I don't know the internal diameter I'm hoping it's 31.5mm then I can continue researching.
If anyone has one lying around or access to one I would really appreciate it.
Cheers, Frank.
Posted: Mon Nov 10, 2003 6:59 pm
by billsta
here frank.
see if this help.
i havent looked at it yet, but you konw what you're looking for..
am i thinking what you're thinking?
the link might help.
http://www.novak-adapt.com/catalog/model_231_parts.htm
Posted: Mon Nov 10, 2003 7:37 pm
by Bitsamissin
Thanks for that Bill, it has helped, it's definitely a coarse 23 spline I just need that internal diameter measurement.
Might send them an email.
Or has any Jeep dudes in Melbourne got a tranny (auto or manual) laying about (separated from the t/case) so I could come over and SLIDE MY LARGE COARSE 23 SPLINE MITSU INPUT GEAR OVER THEIR LUBRICATED THICK JEEP OUTPUT SHAFT
Posted: Tue Nov 11, 2003 9:23 am
by Wooders
I have a spare np231 & TF999 sitting sperately on my garage floor....but that's in Sydney
Posted: Tue Nov 11, 2003 11:50 am
by alanc
Frank,
Would it be feasable to mail the greasy input gear to sydney for a fit check on that NP231J?
Al.
Posted: Tue Nov 11, 2003 5:16 pm
by Bitsamissin
Al, I tried Marks 4wd Adaptors and they gave me a couple of local contacts to try one a huge Jeep joint here in Melbourne so I'll see how it goes.
Frank.
Posted: Tue Nov 18, 2003 12:08 pm
by alanc
Frank,
Did you get time to check on the 23 spline mitz/jeep issue and if so how did it come out?
Regards, Al.
Posted: Tue Nov 18, 2003 4:42 pm
by Bitsamissin
Al, hope to have an answer this friday (day off work for research
Frank.