Page 1 of 1
GQ 4.6 Front Diff into MQ Patrol with 4.625???
Posted: Thu Jan 04, 2007 12:30 pm
by Rosey55
Hi Guys,
Is this likely to cause problems? GQ 4.6 Front Diff under a MQ with a 4.625 in the rear? Anyone done it? I would guess it could put some additional load on drive train?
cheers
Posted: Thu Jan 04, 2007 4:16 pm
by stool
Gq is 4.625:1 as well so all is good
Posted: Fri Jan 05, 2007 5:56 pm
by ludacris
You can use GQ CV,s in the MQ front diff. Not sure if anything has to be moded but if that is why you want to change the complete diff over might be easier to sort than thought of.
LudaCris
Posted: Sat Jan 06, 2007 5:21 pm
by Spartacus
ludacris wrote:You can use GQ CV,s in the MQ front diff. Not sure if anything has to be moded but if that is why you want to change the complete diff over might be easier to sort than thought of.
LudaCris
arent the gqs axles wider? i wonder how it works
Posted: Sat Jan 06, 2007 7:13 pm
by Woop
You need to look for a GQ leafsprung front axle housing--ie early GQute--Then a GQ front diff center to fit into it.. I think its the same width as an MQ/MK rear axle..
Nick
Posted: Mon Jan 08, 2007 7:45 am
by Rosey55
nar doing it for a coil MQ project i've started. MQ/GQ chassis are the same width so the GQ diff should go straight under with some new mounts on the chassis
thanks for the input everyone.