Outer Limits 4x4 Board

why not try one of these 12v touchscreen - and use an onscreen keyboard

http://www.brashimports.com.au/8%20Inch ... Screen.htm

6.5in fit in perfect both front & rear... if you get the Alpine d-drive series they even come with plugs for the nissan wiring.

1986 RJ70 (22R, G52) Bundera

Is it a straight swap or are there adapters/bellhousing changes required?

Is the W56 or R150F a better/simpler option?

What should it cost to rebuild a G52?

thanks

Looking at what fits without major mods... and $$$...

Will the mod need an engineers report?


thanks

dumbdunce wrote:

RUFF wrote:Is 4.5 the factory Ratio in Petrol Bundies? I just always thought they had 4.3s and this was just an Odd one that had 4.5s in it.

have seen both, but yes I think the 4.3 are far more common.

I believe the petrol hardtops got 4.3s and the softtops 4.5s...

What can I expect to pay for the conversion?

I have already sourced a doner vehicle just need a mechanic.


thanks

Anyone know what I should be paying for a 4.556 to 1 Bundera (hiliux) rear crown & pinion - new vs. used ?

PSI3y wrote:ive just finished the 2.8 cressida/supra conversion in my 84 extracab. I believe it is what the car should have had from standard. good overtaking power and great to offroad with. cost me 1500 including expensive stuff ups.

$1500 including motor ?

yep

Anyone done this one?

The engine is currently in a Corolla and has computer and intercooler.

I would assume fuel pump, sump, radiator, ????

I had some work done on my canopy at Croydon Fibreglass. Turned out great.

Manufacturer ???

http://www.hsygroup.com.tw/1HOIST/7HYDRAULIC%20WINCH/KEW8000.htm

Gibonator wrote:i just got my done by motafit, a company that specialise in motor rebuilds, change over cost 2000, thats everything new but then i had me radiator redone and carby redone ...all up was 3000 but it was worth it cause goes hard now

Did the $2000 include the reco 22r and install ????

Anyone fitted a Bosch (or other) ignition coil to replace the original transformer type in the bundy? If so what part number and any installation problems?

Toyota are asking $165 for the std unit which I hear is a very low output unit.

Had the situation on the weekend where low range was engaged but had no drive to the front wheels. After moving the lever in and out of H4/L4 a number of times I finally got drive to the front...

What adjustment is required here?

Cracked block, what a btch!!!!

Already reco'd the head before block damage was detected.


86 Bundera manual....

thanks

Has anyone installed any seats (eg Honda , Nissan, etc.) that mount on the existing Bundera rack?

Are there any aftermaket adapter brackets that suit the Bundera?

Anyone have any suggestions how to join the pieces together after the cut?

dumbdunce wrote:want a proper hard top? mine is for sale

What do you want for it? I'd have to figure out how to get it to Melb!!

I went and saw a lowline that was being sold in the trading post - the thing weighed a tonne! I didn't think I should put my 2.4 under that much strain. Flexiglass Challenge also make a fiberglass one but they want $2500. I can get the FRP top from the wreckers for $300 and I found a boat repairer ...