I was about to part with the zook, however after doing a club run with the Gold Eagle Club i decided against it.
Ive just started the strip...
Mods are as follows...
front air locker
underbonnet compressor (ex falcon)
complete rewire
deepwater lights x2
x2 narva bulls
x4 narva spreads
x2 underbody rock lights
x2 rear lights
new rear bar incorporating swingaway tire mount
new front bar
25W UHF, 27MHZ, VHF, Marine, scanner and phone kit
respray 2 Pac white
35" MTR's on black rims
2 inch chassis spacers
2inch body lift
extended shackes
RS9000's
full cage
marine carpet
wheels spacers
more to come, will submit some piccys soon
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
not selling now....rebuilding
not selling now....rebuilding
1985 LWB Suzuki Sierra, Lock-Rite Rear, SPOA, 2" Body Lift, Climax shackles, Rancho's,
Series 1 Rockhoppers, 31x11.5 MT'S, "To return from the dead very sooooon!"
[url]http://www.cyberdesigns.tk[/url]
[url]http://www.purefmx.tk[/url]
Series 1 Rockhoppers, 31x11.5 MT'S, "To return from the dead very sooooon!"
[url]http://www.cyberdesigns.tk[/url]
[url]http://www.purefmx.tk[/url]
sounds like you've got a shed load of work to do there Pure...
Perhaps some sort of spray on bed liner would be better than marine carpet - just from the point of view that you could 'hose' or scrub it out after a trip rather than always trying to keep the carpet relatively clean...
I'm looking forward to seeing the roll cage too...
Sounds like it's going to be damn tall though... spring over, 35's and a 2" body lift? You are going to be approximately 9.5" over stock in height (assuming your springs are pretty much flat)... If you are keeping the spring over perhaps not running the body lift would be better?
Perhaps some sort of spray on bed liner would be better than marine carpet - just from the point of view that you could 'hose' or scrub it out after a trip rather than always trying to keep the carpet relatively clean...
I'm looking forward to seeing the roll cage too...
Sounds like it's going to be damn tall though... spring over, 35's and a 2" body lift? You are going to be approximately 9.5" over stock in height (assuming your springs are pretty much flat)... If you are keeping the spring over perhaps not running the body lift would be better?
DMA Founding Member #1 - Now Retired
Re: not selling now....rebuilding
purefmx wrote:35" MTR's on black rims
2 inch chassis spacers
2inch body lift
extended shackes
chassis spacers???? please explain.
Skippy
--------------------------------------------------
for all things digital, come to NEWflavour
'a better tasting multimedia experience'
http://www.newflavour.com/
--------------------------------------------------
--------------------------------------------------
for all things digital, come to NEWflavour
'a better tasting multimedia experience'
http://www.newflavour.com/
--------------------------------------------------
Re: not selling now....rebuilding
skippy wrote:chassis spacers???? please explain.
I'm thinking it means Body Lift, or Lowering the spring mounts 2" (i.e. a sub-chassis)...
Still gonna be tall, tall and tall.
DMA Founding Member #1 - Now Retired
wheel spacers are also mentioned... I'm thinking the full 2" variety may be required...
Working on the rule of thumb (as per JP magazine theory), 1.5" wider for every 1" higher...
The car is going to want to be 13.5" wider than stock - minimum... If you want the stability to be the same as it was in stock form...
Working on the rule of thumb (as per JP magazine theory), 1.5" wider for every 1" higher...
The car is going to want to be 13.5" wider than stock - minimum... If you want the stability to be the same as it was in stock form...
DMA Founding Member #1 - Now Retired
2 inch body lift and 2 inch chassis "drop". i.e...spacing the area between the chassis and the spring mounts, she runs std leaves front and rear and yes they're flat, as for the width theory, for now 2 inch whhel spacers plus different offset and then in the near future some GQ diffs. The LWB helps a touch
1985 LWB Suzuki Sierra, Lock-Rite Rear, SPOA, 2" Body Lift, Climax shackles, Rancho's,
Series 1 Rockhoppers, 31x11.5 MT'S, "To return from the dead very sooooon!"
[url]http://www.cyberdesigns.tk[/url]
[url]http://www.purefmx.tk[/url]
Series 1 Rockhoppers, 31x11.5 MT'S, "To return from the dead very sooooon!"
[url]http://www.cyberdesigns.tk[/url]
[url]http://www.purefmx.tk[/url]
purefmx wrote:2 inch body lift and 2 inch chassis "drop". i.e...spacing the area between the chassis and the spring mounts, she runs std leaves front and rear and yes they're flat, as for the width theory, for now 2 inch whhel spacers plus different offset and then in the near future some GQ diffs. The LWB helps a touch
If you are going to be running diffs of a nissan - i'd reckon you could run a bigger tyre than you are planning...
Check out MickBJ42's sierra with the Hilux diffs - he is running a 37" bogger with just a spring over and close to flat springs... I reckon you may be selling your idea a bit short here - perhaps something more like a 39 would be better - goodness knows you are going to have the room to squeeze it in with the body and chassis so far above the axels...
The only consideration would be headlights and firewalls - but if you are running the car so high - you could easily control up-travel (stuff) with sensible use of bumpstops...
Check out LWB Joe from Pirate (who is also on here somewhere) - there are some shots of his car running what i think you are going to be looking at doing and i'm pretty sure his tyres are mucho biggero than 35's...
I'll have a hunt for some pics...
DMA Founding Member #1 - Now Retired
Found some details on it...
http://www.pirate4x4.com/forum/showthre ... light=cage
He's running 42's.
http://www.pirate4x4.com/forum/showthre ... light=cage
He's running 42's.
DMA Founding Member #1 - Now Retired
It all comes down to dollars in the end. I can justify spending around 3000 dollars for the above mentioned mods, but i cant then double that cost to purchase a set of 37" or 38.5" tyres. Ill do the mods listed for now, hopefully finished within 3 weeks and see what happens from there as for the LWB on pirate that thing looks great! Its huge, has he now swapped to coils or is it just my eyes?
1985 LWB Suzuki Sierra, Lock-Rite Rear, SPOA, 2" Body Lift, Climax shackles, Rancho's,
Series 1 Rockhoppers, 31x11.5 MT'S, "To return from the dead very sooooon!"
[url]http://www.cyberdesigns.tk[/url]
[url]http://www.purefmx.tk[/url]
Series 1 Rockhoppers, 31x11.5 MT'S, "To return from the dead very sooooon!"
[url]http://www.cyberdesigns.tk[/url]
[url]http://www.purefmx.tk[/url]
will post more on the weekend, mods are goin good, should have it painted by monday
1985 LWB Suzuki Sierra, Lock-Rite Rear, SPOA, 2" Body Lift, Climax shackles, Rancho's,
Series 1 Rockhoppers, 31x11.5 MT'S, "To return from the dead very sooooon!"
[url]http://www.cyberdesigns.tk[/url]
[url]http://www.purefmx.tk[/url]
Series 1 Rockhoppers, 31x11.5 MT'S, "To return from the dead very sooooon!"
[url]http://www.cyberdesigns.tk[/url]
[url]http://www.purefmx.tk[/url]
Who is online
Users browsing this forum: No registered users and 31 guests