Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
1kzte problems
Moderators: toaddog, Elmo, DUDELUX
1kzte problems
Hi all i swapped my 5L engine in my 1998 hilux for a 1KZTE. When ceruising along it seems to rev out at 3500 to 4000 rpm and it wont pull very well in 4th and 5th gear i can only get a max 100 maybe 110 kms out of it and that is at about at 2500rpm in 5th gear. What do other people get from their turbo diesel 1kzte cars. Can somebody help me.
Resident Terrorist
Re: 1kzte problems
You didnt leave the turbo off did you?lar2784 wrote:Hi all i swapped my 5L engine in my 1998 hilux for a 1KZTE. When ceruising along it seems to rev out at 3500 to 4000 rpm and it wont pull very well in 4th and 5th gear i can only get a max 100 maybe 110 kms out of it and that is at about at 2500rpm in 5th gear. What do other people get from their turbo diesel 1kzte cars. Can somebody help me.
Got a boost guage?
Did you just swap the long engine over or the whole engine and wiring loom and ecu?
Are you getting full throttle, fuel lines plumbed up correctly?
The list can go on. But start with basics.
Are you getting full throttle, fuel lines plumbed up correctly?
The list can go on. But start with basics.
www.diesel-tec.com.au Ph 03 9739 5031
Ball bearing turbo upgrades for factory turbo vehicles. Got a diesel question just ask.
Home of the twin turbo shorty and many 150rwkw+ patrols.
Ball bearing turbo upgrades for factory turbo vehicles. Got a diesel question just ask.
Home of the twin turbo shorty and many 150rwkw+ patrols.
I never got any more than 4000rpm out of mine either. They arnt that strong a motor up top but normal cruising around 120 - 130km should be out of the question. The fastest mine ever went was 140 and that was after a loooooong straight.
My auto cruised at about 2300rpm at 110km/h.
Alec
My auto cruised at about 2300rpm at 110km/h.
Alec
GO the 80...The mods have started :-)
1kzte
from the ones I have driven, they seem to top out at about 140-145, I've got a stocker auto 2LTE surf, only mods are no egr and free wheeling hubs and it easily gets to 120 and on a long straight it managed 145, but at 110 it does 2950rpm, it doesn't go too bad for a lump of a car with a 2.4 diesel auto, I had the same motor in a manual 82 dual cab with a big exhaust and 4.88 gears and it easily would go past the speedo end of 140 but not a safe as the surf and it was a 4 speed so it was revving out past 4200
no they dont- they have a valve in the throttle body to shut the air flow down to assist in a smooth shut down, but theres no butterfly in there to regulate power output (1- it would screw the engine up, diesels take full gulps of air and vary the fuel level to regulate torque, not like a petrol which starves air)
The later fly by wire 1KZ-TE's have got an electric throttle position sensor on the intake body instead of the cable like the early ones did.
Just on an aside, im considering this swap with a LN106 to replace my 2.8D, what kind of work needed doing and how much did it set you back if you dont mind me asking
The later fly by wire 1KZ-TE's have got an electric throttle position sensor on the intake body instead of the cable like the early ones did.
Just on an aside, im considering this swap with a LN106 to replace my 2.8D, what kind of work needed doing and how much did it set you back if you dont mind me asking
2005 HDJ100 Manual, ARB bar, XD9000 winch, ARB rooftop tent + awning, Drawers, Engel, 2" OME lift, 285/75R16 KM2's, iCom, HID XGT's.
hi ferrit thanks. I found a crashed 01 model with the 1kzte engine in it for 4500 and i have probably spent about a 1000 more just on things i had to move the engine mounts and the centre bearing didnt line up so i had to get that shortened. But i swapped everything from the donor car engine gearbox ecu and complete wiring loom.
Bastard!
So far ive been quoted $7700 for a 1KZ-TE from a lux with ecu and loom, and another $2500 for the gearbox!!!
Shoulda bought that 2000 prado TD i saw on ebay in sydney for $9500
So far ive been quoted $7700 for a 1KZ-TE from a lux with ecu and loom, and another $2500 for the gearbox!!!
Shoulda bought that 2000 prado TD i saw on ebay in sydney for $9500
2005 HDJ100 Manual, ARB bar, XD9000 winch, ARB rooftop tent + awning, Drawers, Engel, 2" OME lift, 285/75R16 KM2's, iCom, HID XGT's.
Who is online
Users browsing this forum: No registered users and 107 guests