Cheap drawer carpet

Post by **bundytunna** » Fri Oct 03, 2003 8:58 pm

anyone know where to get some cheap good grade carpet for a set of rear drawers in vic from ?
tried clark rubber bit too $$$$

Post by **Ruggers** » Fri Oct 03, 2003 9:22 pm

if your near laverton try the local market. there is a guy that sells carpet very cheap. i got some to carpet the bottom of my kart trailer. he has rubber and marine carpet which im going to line the bottom of my cruiser with and get rid of the shagpile thats in it. other markets might be worth try

Post by **MUSS** » Fri Oct 03, 2003 9:45 pm

go SPOTLIGHT :rofl:

Post by **V8Patrol** » Fri Oct 03, 2003 11:26 pm

A local shop called "***** This and That" sells cheap stuff....cost under $20 to do a whole patrol floor !!!!.
pm me for a phone number if ya like, I'm sure they'd do a cod delivery 4 ya

Post by **bundytunna** » Sat Oct 04, 2003 9:49 am

im near bloody dandy :bad-words:

spotlight ya reckon eh?

Post by **TuffRR** » Sat Oct 04, 2003 1:33 pm

For mine, I just went to the local carpet store and looked through the offcuts that would match, and then they cut it to size for me.

It was pretty cheap too!

Post by **bogged** » Sat Oct 04, 2003 2:33 pm

got mine from bunnings.

Post by **DamTriton** » Sat Oct 04, 2003 6:13 pm

If you are after enough to do the complete inside and outside of your drawers, try some of the auction houses. Lots of commercial properties have their carpet replaced with a change of tennants. Cheap as shit too.

Post by **DaveS3** » Sat Oct 04, 2003 7:17 pm

Try the dandy market - theres quite a few material and carpet stalls there, at one stage they had all the marine spec carpet, dont know at what price, but drop in
Dave

Post by **Area54** » Sat Oct 04, 2003 8:48 pm

bogged wrote:got mine from bunnings.

Yeah, go the bunnings option.

Post by **bundytunna** » Sat Oct 04, 2003 10:02 pm

cool fellas

will check out bunnings and a few markets
also the industrial carpet mobs
im thinking of using some laminex on the bottom of the drawers and bases(made from chipboard - no rollers)
this should make it roll easyer and it wont drag on the bottom of the drawer
thought id share that tip lol
thanks again

Post by **bogged** » Sun Oct 05, 2003 9:41 am

bundytunna wrote: drawers and bases(made from chipboard -

Spend the extra and use GOOD quality Plywood.. worth the extra. chipboard is shit specially if it gets wet.

Post by **bundytunna** » Sun Oct 05, 2003 5:25 pm

Spend the extra and use GOOD quality Plywood.. worth the extra. chipboard is shit specially if it gets wet.

oops
too late

i had a heap of chipboard lying round so i just used that
cheap anyways

Outer Limits 4x4 Board

Cheap drawer carpet

Cheap drawer carpet

Re: Cheap drawer carpet

Re: Cheap drawer carpet

Who is online