yeah i know they have a rep of being as weak as piss, but has anyone had any experience with one failing? not bearing failure, but shaft/gear failure? Thinking of putting one behind my isuzu 110, so it would be under a bit of torque.
can you engage them on the run, like the pommy electric GKN?
Also does anyone have one laying around they would sell, suit 4 speed rangie, working or broken?
Andy
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
fairy overdrives?
Moderator: Micka
I had one in a Rangie long ago.
Its unlikely the major brearings will fail as they are Rover LT95.
I think the gears are also rover.
They are synchro so you can change at any speed.
BUT
When I bought mine it had a gone ( completely) thrust washer and the needle bearings between the inner and outer shaft were shot and the machining on the outer shaft was "brinnelled".
These seem to be fragile , but you can get needle rollers with an outer race which are the same ID/OD.
I had a friend run up a new thrust washer.
After a couple of years it would jump out of gear,when the car was in 1st /low range ,overriding down a hill and the Fairey box in low.
I never worked out whether it was the Fairey or play in the gearbox main shaft but it could be scarey at times.
With the Isuzu I think you will have problems with thrust washers and needle bearings , even if you use it only as an overdrive in 4th high..
Regards Philip A
Its unlikely the major brearings will fail as they are Rover LT95.
I think the gears are also rover.
They are synchro so you can change at any speed.
BUT
When I bought mine it had a gone ( completely) thrust washer and the needle bearings between the inner and outer shaft were shot and the machining on the outer shaft was "brinnelled".
These seem to be fragile , but you can get needle rollers with an outer race which are the same ID/OD.
I had a friend run up a new thrust washer.
After a couple of years it would jump out of gear,when the car was in 1st /low range ,overriding down a hill and the Fairey box in low.
I never worked out whether it was the Fairey or play in the gearbox main shaft but it could be scarey at times.
With the Isuzu I think you will have problems with thrust washers and needle bearings , even if you use it only as an overdrive in 4th high..
Regards Philip A
Was that an LT95/Rangie fairey or a series fairey - they are completely different animals.disco200tdi wrote:A friend had one on the back of a 3.6 Isuzu LR and broke the overdrive case.
He thinks that maybe one day he will use whats left to make an underdrive.
_____________________________________________________________
RUFF wrote:Beally STFU Your becoming a real PITA.
Who is online
Users browsing this forum: No registered users and 25 guests