Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

60's Rear Wipers

Tech Talk for Cruiser owners.

Moderators: toaddog, Elmo, DUDELUX

Post Reply
Posts: 1031
Joined: Sun May 01, 2005 10:22 pm
Location: Newcastle 2300

60's Rear Wipers

Post by joel HJ60 »

The tubing that carries the water from the bag to the rear sprayer has shit itself on my 60. I've had a look and the tubing runs from the rear door up then into the rear roof, crosses to the other side, then back down to the bag. How do I get access to the roof to replace? Or is there another way?
[b]1985 HJ60[/b]

[url]http://forum.ih8mud.com/60-series-wagons[/url]
Posts: 5179
Joined: Fri Dec 05, 2003 8:15 pm
Location: Brisbane Australia

Re: 60's Rear Wipers

Post by Shadow »

joel HJ60 wrote:The tubing that carries the water from the bag to the rear sprayer has shit itself on my 60. I've had a look and the tubing runs from the rear door up then into the rear roof, crosses to the other side, then back down to the bag. How do I get access to the roof to replace? Or is there another way?
tape the new tube to the old tube and pull it all through.
Posts: 1031
Joined: Sun May 01, 2005 10:22 pm
Location: Newcastle 2300

Post by joel HJ60 »

This was my first thought, but I'd still like to know how (if possible) to get into there. If you can at all.
[b]1985 HJ60[/b]

[url]http://forum.ih8mud.com/60-series-wagons[/url]
Posts: 32
Joined: Tue Nov 28, 2006 9:18 pm

Post by davec »

hey joel fixed mine a while back,yuo'll have to remove the liner a bit,pain in the butt job,mine was leaking at small plastic connector on waterpipe,near where it exits the roof then into rear door,check those little connectors,mine had a small crack,replaced all the pipe and still leakin,couldnt work it out for a while.
cheers
Posts: 1031
Joined: Sun May 01, 2005 10:22 pm
Location: Newcastle 2300

Post by joel HJ60 »

davec wrote:hey joel fixed mine a while back, you'll have to remove the liner a bit, pain in the butt job, mine was leaking at small plastic connector on waterpipe, near where it exits the roof then into rear door, check those little connectors, mine had a small crack, replaced all the pipe and still leakin, couldnt work it out for a while.
cheers
Yeah mine had completely split in two where it flops around where the rear door opens up. I thought Shadow's idea was the go but it seems it's taped to some electrics (for the rear power lock) in there. What's involved in taking the lining out?
[b]1985 HJ60[/b]

[url]http://forum.ih8mud.com/60-series-wagons[/url]
Posts: 32
Joined: Tue Nov 28, 2006 9:18 pm

Post by davec »

no dont take it out,need to lift it at rear above the doors to gain access,put it back on with some contact adhesive,it might wrap around under the rear door seal if i remember,been a while.

cheers dave

ps: if your gonna go to the trouble joel dont muck around with it,replace all the hose while your in there,repco or someone will have it in stock.
Posts: 1031
Joined: Sun May 01, 2005 10:22 pm
Location: Newcastle 2300

Post by joel HJ60 »

Yeah Dave scored some 3mm vinyl tubing from Bunnings for about $4. Will sort it out this weekend. I just want it to spray, ha.
[b]1985 HJ60[/b]

[url]http://forum.ih8mud.com/60-series-wagons[/url]
Posts: 32
Joined: Tue Nov 28, 2006 9:18 pm

Post by davec »

yeah its pretty handy when its dusty hey

cheers dave
Posts: 413
Joined: Sun May 29, 2005 11:35 pm
Location: Launceston, Tas

Post by Sixty's Guy »

Hey Joel, after reading this I replaced mine last night. Mine was broken same place as yours - in the rubber bit from the door to the body. I used 4mm tube (ID). You'll need about 4.5 metres. It's not too hard. I used a bit of yellow tongue off timber flooring and a coat hanger along with some electrical tape to feed the tube through. It helps if you have an assistant at times too. It took about 2.5 hours all up.
Make sure that you drain the bladder first! I pulled off the hose and had water everywhere!

After did this I realised that my rear windscreen wiper doesn't work either. I got a headache trying to work out if it was the motor or the switch. I'll have a chat to the local auto sparky today.
AKA Mark.
1983 HJ60 - 2" OME springs, Bilstein shocks, 2" Bodylift, 35" BFG MT, Twin Lock Rights, Longfields, Denco Turbo, Ironman Winch
1975 FJ55 - stocko, but with power steering!
Posts: 1031
Joined: Sun May 01, 2005 10:22 pm
Location: Newcastle 2300

Post by joel HJ60 »

Thanks Mark, I'll tackle it on Sunday. PM sent.
[b]1985 HJ60[/b]

[url]http://forum.ih8mud.com/60-series-wagons[/url]
Posts: 237
Joined: Tue Dec 20, 2005 9:23 pm
Location: Rosebud vic

Post by juzzydykes75 »

i recent;y did mine and if all else fails just pull the pinch strip off the back of the roof trim and the hose is just inside there in the back roof crosspanel . that way you dont need to pull much trim down . then when finished just fold it back over the lip and use the pinch strip to hold it there . took me about 10 mins to replace the whole tube including finding where it was .
1991 Hdj80 ,
Posts: 1031
Joined: Sun May 01, 2005 10:22 pm
Location: Newcastle 2300

Post by joel HJ60 »

All over this today. Removed the back part of trim off the roof and sorted it all out. Not a bad job.
[b]1985 HJ60[/b]

[url]http://forum.ih8mud.com/60-series-wagons[/url]
Post Reply

Who is online

Users browsing this forum: No registered users and 10 guests