Trailing Arms

Post by **GURU** » Mon Oct 20, 2003 7:37 pm

G'day all,

I am now making and selling trailing arms. They are a bolt in arm with a Hemi/Rose joint on the diff end. But I will also make some with the standard fitting on the diff end if you are worried about engineering. They will be made to order and the bend will be made to the spec's of your vehicle (unless you specify differently).

They are made out of 34mm tube and 7mm wall. there will be a money back guarantee on them too. If your not happy then send them back, no problems.

Price: $500 a pair

I am getting some springs made to get maximum flex available out of the trailing arms.

I will also be making a bolt in A-frame mod in the future.

Post by **modman** » Mon Oct 20, 2003 8:58 pm

good timing, i just bent one of mine!
would you consider making them with a johnny joint or similar from calbah big balls or wizard.
just from an engineering poirt of view?

thanks,
modman.

Post by **GURU** » Tue Oct 21, 2003 12:31 am

Check PM

Post by **Gazzaj** » Thu Oct 23, 2003 4:43 pm

bit small make longer

Outer Limits 4x4 Board

Trailing Arms

Trailing Arms

Who is online