Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

triton enquiry

Tech Talk for Mitsubishi owners.

Moderator: -Scott-

Post Reply
Posts: 36
Joined: Fri Nov 07, 2003 7:49 am
Location: canberra

triton enquiry

Post by alanc »

Hi, Hav'nt had any input re my Triton/L200 rear end enquiry.
I have done a bit of research at the local mitsi dealer and have the following info. It may be suitable for tech section.
Diff by engine type.
4G64-4D5Turbo..............4.875
4D5 non turbo................4.875
6G7...............................4.9
4M40.............................4.636

Near as I can tell, there is a track change around 2002 from 1435mm to 1480mm and a diff center/axle change 2003.
All Triton/L200 have high front pinions.

If anyone can add to this I would appreciate input.

It seems that in order to get a wider diff then I will have mismatched ratios front to rear. ie 4.9 to 4.875 or 4.636 to 4.625. The latter pair are closer.
Both these pairs equate to tread wear difference of 2 mm or less on 31,s.
Since I don't drive on hard surfaces then the difference should not matter.
Any comments?

Thanks, Al
Posts: 191
Joined: Sat Jan 18, 2003 6:23 pm
Location: melb

Post by pickle »

You have it arse about!

6G7......4.636
4M40....4.900
Dave
Posts: 36
Joined: Fri Nov 07, 2003 7:49 am
Location: canberra

Hmmmm!

Post by alanc »

Hi Dave,
I will check again but the factory book definitly puts the diesel with the taller diff. The only other reference I have seen on vehicle specs list was a 3Ltr petrol with a 4.9 final drive.
Challenger listed 4.636 for both petrol and diesel, man and auto.
Thanks for your comment, I will check it out.
Al
Posts: 14209
Joined: Sun Jan 11, 2004 11:36 am
Location: Adelaide

Post by -Scott- »

Find out if the 4M40 is turbo or NA - that might make a difference.
Post Reply

Who is online

Users browsing this forum: No registered users and 29 guests