The 1Kz-te installation is going fine. The engine and gearbox already in. New engine mounts had to be fitted. The engine is already fired up, buts its a little noisy as there's no exhaust yet.
Is it possible to fit 100 series axles to a LJ70 (bundy)? I know the most common upgrade is to 80 series. There's a good pair available and both axles have factory lockers. lj70 is coil sprung.
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
Axle change on LJ70?? and 1kz-te installation report
Moderators: toaddog, Elmo, DUDELUX
Who is online
Users browsing this forum: No registered users and 0 guests