GQ Auto trans lockup

[GUJohnno]

I'm in the middle of setting up a lock up switch to my deisel auto following the instructions here: http://members.bettanet.net.au/~conody/ ... Switch.htm

Thing is; the module in the GU is different to the GQ. In the write up Chaz states that you cut into the green wire with orange stripe. On the GQ there are two green wires with orange stripes.

Any one on here done this before and remember which wire they used?

Cheers,
John.

[bogged]

there was a thread here by Robbie yrs back, and a few others that had done it, see if you can find it by searching by author..

[GUJohnno]

there was a thread here by Robbie yrs back, and a few others that had done it, see if you can find it by searching by author..

I've searched through all of the threads and still need to confirm the correct wire. I think I have it sussed but want to be sure before cutting and wires.

[GUJohnno]

OK all sorted out now.
I need to tap into the Grey wire with Red stripe that is in terminal 22.

Wiring diagram can be found here
http://www.downunder4x4.net/holdswitch.jpg

Instructions (for 3.0Ltr Gu) here
http://members.bettanet.net.au/~conody/ ... Switch.htm