Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

Diesel hits a wall at 2300rpm under load.

General Tech Talk

Moderators: toaddog, TWISTY, V8Patrol, Moderators

Post Reply
Posts: 792
Joined: Mon Jan 05, 2004 4:43 pm
Location: Campbelltown, Sydney

Diesel hits a wall at 2300rpm under load.

Post by Nev62 »

Having problems with my 6.5 n/a. At first it was tacking loudly and had no power under load. Took it to a shop and had the injectors and injector pump rebuilt. I also had the single filter replaced with a double unit. It was a bit better but at 2000rpm when under load would hit a brick wall and actually start to slow down and hold at around 1800RPM.

I have an old fuel pump that was a bit sus but had been working in the past so decided to try that. Things got worse and it would not go past 1800 under load (this meant 30-40kmh going up hills.

I brought a new carter lift pump that is 7psi and 72gph. It is now almost back to normal but hits a wall at 2300rpm under heavy load and holds there till the load comes off.

The auto is very tired but I would think it would silp if anything and let the engine spin, not bog it down.

I have a theroy that goes something like this;
Injector pump was rebuilt to the upper limits, according to the manifactors specs, allowing for more fuel (so the rebuilder tells me). The injectors were rebuilt to match the injector pump. With this in mind, the additional filter adding to flow restriction and the new fuel requirement of the injector pump and injectors, the 7psi pickup pump prior to the filters is no longer powerful enough to supply the required fuel.

Sound plausable???

Any ideas? Did the shop charge me $4400 and stuff the job on the injection pump? Is the dual filter causing too much restriction to the flow and/or pressure? Should I add my old pickup pump after the filters to help with the supply? Anyone???
FJ62 Crusier GM V8 Diesel Lockers 33 MTs/35 117 extremes
Macarthur District 4WD Club http://www.macarthur4wdclub.com.au
Posts: 567
Joined: Fri Jul 20, 2007 7:37 am
Location: Panama

Post by Tapage »

Why not start with simple test ( I'm not a Chevy expert .. ) try one filter ( I thought it not gonna make the diference but give a try ) and a ride test ..
HJ-60 2H-T Intercoled [url=http://4x4panama.com/foros/viewtopic.php?t=2770]Tencha[/url]
HDJ-80 1HD-T Stock so far " Marilu "
Panama
Posts: 2254
Joined: Tue Dec 10, 2002 5:09 pm
Location: Sydney

Re: Diesel hits a wall at 2300rpm under load.

Post by jessie928 »

Nev62 wrote:Having problems with my 6.5 n/a. At first it was tacking loudly and had no power under load. Took it to a shop and had the injectors and injector pump rebuilt. I also had the single filter replaced with a double unit. It was a bit better but at 2000rpm when under load would hit a brick wall and actually start to slow down and hold at around 1800RPM.

I have an old fuel pump that was a bit sus but had been working in the past so decided to try that. Things got worse and it would not go past 1800 under load (this meant 30-40kmh going up hills.

I brought a new carter lift pump that is 7psi and 72gph. It is now almost back to normal but hits a wall at 2300rpm under heavy load and holds there till the load comes off.

The auto is very tired but I would think it would silp if anything and let the engine spin, not bog it down.

I have a theroy that goes something like this;
Injector pump was rebuilt to the upper limits, according to the manifactors specs, allowing for more fuel (so the rebuilder tells me). The injectors were rebuilt to match the injector pump. With this in mind, the additional filter adding to flow restriction and the new fuel requirement of the injector pump and injectors, the 7psi pickup pump prior to the filters is no longer powerful enough to supply the required fuel.

Sound plausable???

Any ideas? Did the shop charge me $4400 and stuff the job on the injection pump? Is the dual filter causing too much restriction to the flow and/or pressure? Should I add my old pickup pump after the filters to help with the supply? Anyone???
4400 for an IP rebuild? FARRRRRR OUT MAN.

http://cgi.ebay.com/ebaymotors/GMC-CHEV ... enameZWD1V
http://cgi.ebay.com/ebaymotors/6-5-6-5L ... enameZWDVW


do youi know what a new pump and injectors is worth from the states?

Jes
ATTACH BROKEN TOYOTA HERE--->
DUCATI <-----Worlds best warning label
Posts: 2809
Joined: Mon Jan 02, 2006 5:03 pm
Location: Lara Victoria

Post by Ruffy »

The filters would have to have a problem to cause a restriction like that.
It does, however, sound like you're running out of fuel.
If you took it in for this problem in the first place then take it back!
[quote="Uhhohh"]As far as an indecent proposal goes, I'd accept nothing less than $100,000 to tolerate buggery. Any less and it's just not worth the psychological trauma. [/quote]
Posts: 748
Joined: Tue Nov 09, 2004 9:45 pm
Location: Lilydale

Post by Dzltec »

Is the engine missfiring and running rough when it wont rev anymore? If so its a fuel supply problem, either from restrictions, lack of supply or air enetring the system.

Have you checked full thottle at the pump. Is the lever touching the stopper bolt?


Will this rever higher in nuetral? Try hooking up a external fuel source and see what happens.


Andy
www.diesel-tec.com.au Ph 03 9739 5031
Ball bearing turbo upgrades for factory turbo vehicles. Got a diesel question just ask.
Home of the twin turbo shorty and many 150rwkw+ patrols.
Posts: 3523
Joined: Fri Aug 27, 2004 12:27 am
Location: Fairfield,Sydney

Post by pongo »

are you sure 7psi is enough. My old sd33 runs the equivelent of a holley black which is set at about 16psi i think and is mounted near the tank.

I ended up having to run a slightly larger fuel line as well, IT has sorted my issues with the old girl and shes std.

Maybe try a larger fuel line to see if it helps. Psi does pressure but maybe still not enough volume when the goveners open up.

CHeers
Posts: 2254
Joined: Tue Dec 10, 2002 5:09 pm
Location: Sydney

Post by jessie928 »

pongo wrote:are you sure 7psi is enough. My old sd33 runs the equivelent of a holley black which is set at about 16psi i think and is mounted near the tank.

I ended up having to run a slightly larger fuel line as well, IT has sorted my issues with the old girl and shes std.

Maybe try a larger fuel line to see if it helps. Psi does pressure but maybe still not enough volume when the goveners open up.

CHeers
you need higher pressuer with veggie oil :)
ATTACH BROKEN TOYOTA HERE--->
DUCATI <-----Worlds best warning label
Posts: 2492
Joined: Sun Nov 24, 2002 8:57 pm
Location: Melbourne

Post by bazzle »

Always check, change filters 1st. If it is on veggie oil they block filter real quick (Iv seen 60 kilometers from loosened gunk)
Tyr a bit of clear line in fuel run temporarily to ensure no air bubbles, (Air can get sucked in thru hose or end )

Bazzle
Posts: 592
Joined: Wed Apr 19, 2006 8:19 pm
Location: ipswich

Post by rover1 »

my patrol used to do this, i thought it was a fuel issue, but turns out it wasn't getting enough air. i took the top off my air filter and took it for a strap around the block and bingo, like driving a new car.
cheers Pete.

its the skinny pedal
Posts: 2158
Joined: Sat Jan 20, 2007 8:16 am
Location: New Zealand

Post by KiwiBacon »

rover1 wrote:my patrol used to do this, i thought it was a fuel issue, but turns out it wasn't getting enough air. i took the top off my air filter and took it for a strap around the block and bingo, like driving a new car.
A diesel will be blowing a lot of black smoke if air is the issue.
Posts: 792
Joined: Mon Jan 05, 2004 4:43 pm
Location: Campbelltown, Sydney

Post by Nev62 »

Ruffy wrote:The filters would have to have a problem to cause a restriction like that.
It does, however, sound like you're running out of fuel.
If you took it in for this problem in the first place then take it back!
It is going back tomorrow!
Have you checked full thottle at the pump. Is the lever touching the stopper bolt?
Yep, get full thottle
Will this rever higher in nuetral? Try hooking up a external fuel source and see what happens
Yep will rev all day long in netural or no load
are you sure 7psi is enough
GM specs are for 4-6psi so 7psi is more than enough.
Psi does pressure but maybe still not enough volume when the goveners open up.
Pump is rated at 72gph

No veggie oil and no air found.

No black smoke.
FJ62 Crusier GM V8 Diesel Lockers 33 MTs/35 117 extremes
Macarthur District 4WD Club http://www.macarthur4wdclub.com.au
Posts: 748
Joined: Tue Nov 09, 2004 9:45 pm
Location: Lilydale

Post by Dzltec »

What tyres are on this? Are they at correct pressure? We have had patrols that wont go through a full run on our dyno because of low pressured centipedes.


Andy
www.diesel-tec.com.au Ph 03 9739 5031
Ball bearing turbo upgrades for factory turbo vehicles. Got a diesel question just ask.
Home of the twin turbo shorty and many 150rwkw+ patrols.
Posts: 792
Joined: Mon Jan 05, 2004 4:43 pm
Location: Campbelltown, Sydney

Post by Nev62 »

Problem FOUND! It is the new dual filter setup :? I bye-passed them to see what would happen and low and behold, the power is back. It still seems a bit wanting but is now increasing RPM under heavy load (steep hill and the boot put in). This is actually better then before the work done to it (would just hold and not increase under very heavy load). \

Now the question is do I put my two carter pumps inline (near the fuel tank were one is now), or place one in the engine bay after the filters?
FJ62 Crusier GM V8 Diesel Lockers 33 MTs/35 117 extremes
Macarthur District 4WD Club http://www.macarthur4wdclub.com.au
Posts: 1175
Joined: Wed Jul 27, 2005 10:17 pm
Location: Mirboo North

Post by 6.5 rangie »

Nev, i run a carter at the tank, one filter in the engine bay, and a fuel pressure reg (6-9psi, running around 7 aswell) after the filter. My pump is modded and the injecters to suit (pump cost $1200 to buy outright and modded, injecters were $80each to rebuild, you may have been ripped a bit). Good thing you've found the problem though. :)
Damien


--------------------------------------------------------
Posts: 792
Joined: Mon Jan 05, 2004 4:43 pm
Location: Campbelltown, Sydney

Post by Nev62 »

The disappointing part was that I found the source of the problem and not a well know diesel shop that I payed a bucket load to:?
FJ62 Crusier GM V8 Diesel Lockers 33 MTs/35 117 extremes
Macarthur District 4WD Club http://www.macarthur4wdclub.com.au
Posts: 2404
Joined: Fri Jul 07, 2006 9:00 pm
Location: Ipswich

Post by Sic Lux »

Thats gotta suck Kiss principlal keep it simple stuip old one but can be soo true also had a problem like this at work totaly diffrent vehicle passed press test ok flow was a bit down more testing ended up being the tank the holes with the baffels near the pick up were blocked causing it so suck dry and no fuel was going to suggest this but you found it good work.
plenty of parts on the bench
Posts: 3523
Joined: Fri Aug 27, 2004 12:27 am
Location: Fairfield,Sydney

Post by pongo »

in the shorty mk i had, i had a huge drama with inconsitent fuel issues , ended up being carpet strings sucked up the tank pick up. What amazed us is htf did they get there.
Post Reply

Who is online

Users browsing this forum: No registered users and 2 guests