just brought an 80 series and the higheanms will flash when u pull back on the combination switch and if u hol the switch back u can keep them on but the second you push forward on the comb switch to actually turn them on they dont work and the headlights turn off... any ideas guys im thinking relay but not sure..
cheers
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
highbeam wont stay on...
Moderator: -Scott-
how it should work: when you pull back you should have both high and low beam on at the same time. when you push forwards the low turns off and the high comes on
i think it is your switch in the stalk, something missing/broken/out of alignment. if was relay or even wiring/fuse the the high beams wouldn't come on at all
cheers
i think it is your switch in the stalk, something missing/broken/out of alignment. if was relay or even wiring/fuse the the high beams wouldn't come on at all
cheers
Yeah! Wot he sed!Bluey wrote:how it should work: when you pull back you should have both high and low beam on at the same time. when you push forwards the low turns off and the high comes on
i think it is your switch in the stalk, something missing/broken/out of alignment. if was relay or even wiring/fuse the the high beams wouldn't come on at all
cheers
the 40s have a stupid reed switch (which is usually reliable), but it has 2 small copper "reads" with a little copper point on the ends which touches a connection between the two when you push the stalk forward or hold it back. These are subject to corrosion, or the mounts may be bent or broken which is unlikely. Just pull the plastic surrounds and run some emery paper between them. You will see what i mean when you pull it to bits. Sounds like the only thing it can be.
Sam
Sam
when i first got my 87 4runner when i tried to turn on my high beams all my lights turned off and sometimes they worked fine, i read it as being a dodgy contact and just sat and flicked them on and off for about 5 mins. 90% of the time theyll work now and sometimes i still get no light, bit scary all a sudden all the lights turning off but it s gettin better
1987 Tojo 4runner nothing too exciting
My 86 4runner did the same thing, couldn't isolate the problem myself (does the highbeam indicator come on on the dash? if so, could indicate that there is a problem other than a switch)
Took the runner to an auto sparky and he managed to isolate the issue to a damaged wire, fixed it within 20 minutes.
Took the runner to an auto sparky and he managed to isolate the issue to a damaged wire, fixed it within 20 minutes.
Who is online
Users browsing this forum: No registered users and 1 guest