can anyone help me make some sense.
got a new diff centre as my old one was growling.
now i have grief.
no axels can be found to fit that centre and my housing.
im after the fine spline axels to fit the centre.
however i have an early model housing.
as i have spring over all the mounts would have to be redone to change housings??
what are my options?
im told i need a fine spline axel 175mm long with a 32mm flat?
however all the wreckers say they only come in a 25mm flat??
all you 40 nuts i need help.
what can i do??
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
40 series front diff/axel combos?
Moderators: toaddog, Elmo, DUDELUX
Im here for the sausage!
a whole front axle /diff assmebly would cost you between 50 and 300 bucks pending where you get it..
As far as changing the SPOA is concerned.. GET TO IT ! not hard
As far as changing the SPOA is concerned.. GET TO IT ! not hard
45 series ute - 308 -gas -35's- lifted -no flex..But i got air lockers !
2006 VX v8 4.7 Landcruiser, bog stock. It's black so its cool !
2006 VX v8 4.7 Landcruiser, bog stock. It's black so its cool !
Who is online
Users browsing this forum: No registered users and 1 guest