guys have abit of a query with changing the filler neck on my 80 its been cut into a ute and still runs the sedan filler and takes about 10 minutes to fill cause the safety keeps getting trigered. the neck is just floating around so i want to make it straight up from the tank and mount it into the tray..
now the question is what metal tube do i use? will exhaust tube be alright or will it rust? i was thinking with the diesel going through it it shouldnt rust but need to be sure... any ideas? cheers
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
modifying fuel filler neck question?
Moderators: toaddog, TWISTY, V8Patrol, Moderators
IMO go for aluminized exhaust tube and should be sweet. like you said diesel will stop rust on the inside anyway. I reckon where the tank breather tube ends on the filler neck needs to be as close to the end as possible and on the upper side of the filler neck. Also the straighter the filler pipe is the better, specially at the top end.
did this on HQ panel van years ago and made heaps of difference.
did this on HQ panel van years ago and made heaps of difference.
Who is online
Users browsing this forum: No registered users and 1 guest