Notice: We request that you don't just set up a new account at this time if you are a previous user. If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
I have searched and so far it seems that tomorrow i will be off to clark rubber in hope of finding the right profile seal, unless anyone has any other great tips
I just fitted a factory 'plastic' hardtop front and rear, off a 85 nt to my 95 shorty wt sierra, the back sealed up great, but the front has a gap on the sides where the windscreen support frame above the doors is, it needs some kind of seal and the rear bit of the front roof where it meets the b pillar also needs a seal as well.
Any ideas appreciated.
[quote="4runner2.8"]i have one.... and iv done a few long hard pulls with it too.[/quote]
I have a similar problem, i need the "clips" that would hold the front section of such a roof to my sierra. Anyone know where I could pick some up from?
I have fitted a similar roof to a mates car and when we found problems we went to a foam and rubber shop and then went to a hardware shop and not bunnings sort of thing. We actually went to a shop that sells HARDWARE components for different locks and tie downs etc etc.
In the end it went together nicely and seals out the weather. Also cost us approx $50-$60 to complete the task.
I have fitted a similar roof to a mates car and when we found problems we went to a foam and rubber shop and then went to a hardware shop and not bunnings sort of thing. We actually went to a shop that sells HARDWARE components for different locks and tie downs etc etc.
In the end it went together nicely and seals out the weather. Also cost us approx $50-$60 to complete the task.
Yes , I went to a boat chandler and they sold latches for tying down lids etc but they seemed too big. Where are the best spare parts places?
and so far it seems that tomorrow i will be off to clark rubber in hope of finding the right profile seal, unless anyone has any other great tips 
