Check this out.
http://cgi.ebay.com.au/MITSUBISHI-PAJER ... dZViewItem
Does anyone know how this works? Is it Legal?
Burty
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
EGR Blanking Plate How does this work?
Moderator: -Scott-
EGR Blanking Plate How does this work?
Take it Off Road or take it off the road!!!
2003 3.0L GU Patrol Cooper S/T-C's Factory Bar IPF Lights Sat Phone Solar 2nd Battery GME UHF OME Lift Snorkel
2003 3.0L GU Patrol Cooper S/T-C's Factory Bar IPF Lights Sat Phone Solar 2nd Battery GME UHF OME Lift Snorkel
EGRs typically don't "recycle" gases at full throttle, so it shouldn't affect max power. Unless diesel EGRs are different?
Thinking about it more, diesels are an excess-air engine - they should always be combusting all the fuel which is injected. Does a small amount of re-circulated exhaust gas really affect part-throttle power or economy?
Thinking about it more, diesels are an excess-air engine - they should always be combusting all the fuel which is injected. Does a small amount of re-circulated exhaust gas really affect part-throttle power or economy?
Ahh EGR's. Effectively shitting in your own nest.
Your inlet manifold will be filled with soot and Tar, creating a heat sink, cutting air flow and remember heat is what kills these little turbo diesels heads. Recylcing hot air = bad.
Take your inlet manifold off and have alook in it - you'll be shocked. Soak it for a few days and scrub clean with a big bottle brush, block it off at the outlet on the exhaust manifold but leave everything there so it looks factory.
Then be impressed with how your vehicle behaves.
Your inlet manifold will be filled with soot and Tar, creating a heat sink, cutting air flow and remember heat is what kills these little turbo diesels heads. Recylcing hot air = bad.
Take your inlet manifold off and have alook in it - you'll be shocked. Soak it for a few days and scrub clean with a big bottle brush, block it off at the outlet on the exhaust manifold but leave everything there so it looks factory.
Then be impressed with how your vehicle behaves.
1994 NJ SWB, 3.5, 5 speed manual, 33's, XD9000, 4.9 diffs, Front & Rear ARB's, Safari Snorkel
2008-2009-2010-2011 Pavlova in the shed.
2008-2009-2010-2011 Pavlova in the shed.
Who is online
Users browsing this forum: No registered users and 1 guest