Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
High mount winch
Moderators: toaddog, TWISTY, V8Patrol, Moderators
High mount winch
Just wondering if there is anyone who can explain to me in depth how to brace a M8274 high mount winch (picks would be nice) Cheers
weld 2 tabs on each side of the drum housing and end plate on the back (about 1-2 oclock and 4-5 oclock if looking side on with the mounting to your left (vertical))
then put all thread through with 2 nuts sandwiching the tabs you just welded on to form spreader bars (cover with rubber, pvc or aluminum pipe/hose to protect your rope)
this is similar to the spreader bars on a low mount if you get the idea.
also drill the free spool through the freespool housing and pin (2.5mm hole) and put a K or R clip through to prevent it coming out unexpectedly.
and drill the hole in the brake shaft and tap it to put a bolt in and washer to assist the circlip to hold the braking force that can cause the circlip to fail. (this is hardened steel so use a TCT tip drill and good tap and lots of patience!)
also drill and tap drain and fill plugs in the housing and breather in the housing and motor and seal everything really well with good silicone.
add 6hp motor on 24 v and go comping
(search 8274 mods or high mount mods. lots and lots of pics.
then put all thread through with 2 nuts sandwiching the tabs you just welded on to form spreader bars (cover with rubber, pvc or aluminum pipe/hose to protect your rope)
this is similar to the spreader bars on a low mount if you get the idea.
also drill the free spool through the freespool housing and pin (2.5mm hole) and put a K or R clip through to prevent it coming out unexpectedly.
and drill the hole in the brake shaft and tap it to put a bolt in and washer to assist the circlip to hold the braking force that can cause the circlip to fail. (this is hardened steel so use a TCT tip drill and good tap and lots of patience!)
also drill and tap drain and fill plugs in the housing and breather in the housing and motor and seal everything really well with good silicone.
add 6hp motor on 24 v and go comping
(search 8274 mods or high mount mods. lots and lots of pics.
[quote="75 cruser"]we want more donkey[/quote]
Who is online
Users browsing this forum: No registered users and 1 guest