Notice: We request that you don't just set up a new account at this time if you are a previous user. If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
stockman wrote:oh right greg sort of makes sense , yeah ill think ill just leave her and go calmini 5''lift or spring over do u know any companys that sell a weld on spiringover kit in Australia..
Overkill (Sam) and Mickbj42 (Mick) both have companies in NSW that sell springovers - not sure if they come in kits though (as opposed to installations).
I have run 32x11.5 BFG's on 15x8's with a 3.5 inch offset (5.5 inches outside the centreline of the rim) They did not foul anything. (That was on a SPOA vehicle but should clear basically the same SPOA or SPUA as far as springs etc are concerned.
Guy
" If governments are involved in the covering up the knowledge of aliens, Then they are doing a much better job of it than they do of everything else "
