Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

Viscus fan Vs Thermo fan

Tech Talk for Nissan owners.

Moderators: toaddog, V8Patrol

Post Reply
Posts: 29
Joined: Tue May 08, 2007 1:34 pm
Location: Bris vegas

Viscus fan Vs Thermo fan

Post by DA DUDE »

Hi all just sit here wondering whats better Viscus or Thermo fans

Running a 304 efi in a GU with std allo radiator with the viscus fan.
but the fan seem to be on all the time and thats with a new viscus the temp is sitting just under 1/2 way would their be much diffrent's apart the noise the viscus makes
shit happen's & ass holes cause it
Posts: 1575
Joined: Thu Dec 28, 2006 6:50 pm
Location: Moronfield....

Post by nottie »

if unsatisfied have ya tried filling the clutch up with oil (as in the silocone stuff ya can get from toyota) Ya pull the hub apart on the fan and fill it with the the oil. I have allways beleived the factory fans (with a good shroud ) to be better then thermos but im shore i will be corrected.
Posts: 2775
Joined: Thu Apr 13, 2006 8:59 pm
Location: Melbourne

Re: Viscus fan Vs Thermo fan

Post by GQ Bear »

DA DUDE wrote:Hi all just sit here wondering whats better Viscus or Thermo fans

Running a 304 efi in a GU with std allo radiator with the viscus fan.
but the fan seem to be on all the time and thats with a new viscus the temp is sitting just under 1/2 way would their be much diffrent's apart the noise the viscus makes
Of course the viscous fan spins all the time, it's attached to your crankshaft via belts. A thermo fan is electric, usually attached to an electric thermostat switching on or off as thermostat opens. Stick a hammer handle, etc into blades whilst idling. Fan should stop if clutch is working and resistence will build as hub spring heats up. If your temps sitting at under half i'd say you don't have a problem so why change it?
[color=violet]G[/color][color=white]O[/color][color=yellow] S[/color][color=blue]T[/color][color=yellow]O[/color][color=white]R[/color][color=violet]M[/color]
Premiers 1999, 2007, 2009
Spoon 2010
Posts: 848
Joined: Fri Apr 02, 2004 12:01 pm
Location: Central Victoria

Post by Patroler »

Of course the viscous fan spins all the time
yea but it shouldn't drive flat out all the time, i can hear mine start and stop on the highway over the wind noise! - and feel the corresponding power drop when it kicks in up hills! d'oh Also on cold start it spins hard for a few minutes and then you can hear it go quiet when it all frees up!
There are no stupid questions, but there are a LOT of inquisitive idiots
Posts: 29
Joined: Tue May 08, 2007 1:34 pm
Location: Bris vegas

Post by DA DUDE »

well tell this is it because i'm running a diesel viscus fan in a petrol engine is their diffrent's
shit happen's & ass holes cause it
Posts: 310
Joined: Fri May 25, 2007 12:16 am
Location: at the shed gympie

Post by scuba steve 22 »

Patroler wrote:
Of course the viscous fan spins all the time
yea but it shouldn't drive flat out all the time, i can hear mine start and stop on the highway over the wind noise! - and feel the corresponding power drop when it kicks in up hills! d'oh Also on cold start it spins hard for a few minutes and then you can hear it go quiet when it all frees up!
you sure your talking about a viscous fan? a viscous fan is driven by the fan belt, and goes all the time.. when the engine is cool though (startup, easy highway driving) the viscous clutch loosens, and the fan wont do the full rpm the engine is... they dont 'kick' in like a thermo fan... sure your not talking about an auxilary thermo fitted in front of the radiator, usually tied into the air con?
Posts: 14668
Joined: Mon Aug 29, 2005 7:10 pm
Location: western shitney

Post by j-top paj »

Patroler wrote:
Of course the viscous fan spins all the time
yea but it shouldn't drive flat out all the time, i can hear mine start and stop on the highway over the wind noise! - and feel the corresponding power drop when it kicks in up hills! d'oh Also on cold start it spins hard for a few minutes and then you can hear it go quiet when it all frees up!
mine does the same :bad-words:
i need to do something about it before i go on hollidays.
Banzy wrote:Dial up internet.........you'd post something and come back 2 beers later to see if it loaded.
my GU
Posts: 184
Joined: Thu Aug 18, 2005 5:27 am
Location: Melbourne

Post by thomo.in.a.gq »

scuba steve 22 wrote:
Patroler wrote:
Of course the viscous fan spins all the time
yea but it shouldn't drive flat out all the time, i can hear mine start and stop on the highway over the wind noise! - and feel the corresponding power drop when it kicks in up hills! d'oh Also on cold start it spins hard for a few minutes and then you can hear it go quiet when it all frees up!
you sure your talking about a viscous fan? a viscous fan is driven by the fan belt, and goes all the time.. when the engine is cool though (startup, easy highway driving) the viscous clutch loosens, and the fan wont do the full rpm the engine is... they dont 'kick' in like a thermo fan... sure your not talking about an auxilary thermo fitted in front of the radiator, usually tied into the air con?
When the vixcous fans start to seize they run pretty hard all the time, causing the excessive noise and air flow.
GQ Patrol with a few bits and pieces.
Posts: 848
Joined: Fri Apr 02, 2004 12:01 pm
Location: Central Victoria

Post by Patroler »

thomo.in.a.gq wrote:
scuba steve 22 wrote:
Patroler wrote:
Of course the viscous fan spins all the time
yea but it shouldn't drive flat out all the time, i can hear mine start and stop on the highway over the wind noise! - and feel the corresponding power drop when it kicks in up hills! d'oh Also on cold start it spins hard for a few minutes and then you can hear it go quiet when it all frees up!
you sure your talking about a viscous fan? a viscous fan is driven by the fan belt, and goes all the time.. when the engine is cool though (startup, easy highway driving) the viscous clutch loosens, and the fan wont do the full rpm the engine is... they dont 'kick' in like a thermo fan... sure your not talking about an auxilary thermo fitted in front of the radiator, usually tied into the air con?
When the vixcous fans start to seize they run pretty hard all the time, causing the excessive noise and air flow.
Na mines all in pretty good nick 170k 93 gq, only electric fan on the thing is the heater! viscous is belt driven and can spin freely but when you're hitting a big hill and it gets a bit hot the viscous fluid must increase in viscosity and not allow any slip and therefore you can hear and feel(power loss) the fan come on - actually its probably more noticeable when it unlocks (freewheels) after being locked goes quiet all of a sudden.
Also on a hot day 30+ in town its pretty noisy when you rev it (as it should be) as its driving all the time.
they dont 'kick' in like a thermo fan
they pretty much do if they're working well!
There are no stupid questions, but there are a LOT of inquisitive idiots
Posts: 300
Joined: Sun May 20, 2007 2:22 am
Location: Toowoomba QLD

Post by 90Mav »

they dont 'kick' in like a thermo fan

they pretty much do if they're working well!
Hmm. i have a brand new genuine fan on my TD42.. cant say iv'e ever noticet it in any way.. noise power ect...?
Thrashed '90 Leaf spring Maverick ute, TD42, 2" EFS lift. 36 Swampers.
Posts: 14668
Joined: Mon Aug 29, 2005 7:10 pm
Location: western shitney

Post by j-top paj »

90Mav wrote:
they dont 'kick' in like a thermo fan

they pretty much do if they're working well!
Hmm. i have a brand new genuine fan on my TD42.. cant say iv'e ever noticet it in any way.. noise power ect...?
how much did you pay for a genuine one?
Banzy wrote:Dial up internet.........you'd post something and come back 2 beers later to see if it loaded.
my GU
Posts: 300
Joined: Sun May 20, 2007 2:22 am
Location: Toowoomba QLD

Post by 90Mav »

Had it installed under warrenty when i braught the truck..
Thrashed '90 Leaf spring Maverick ute, TD42, 2" EFS lift. 36 Swampers.
Posts: 848
Joined: Fri Apr 02, 2004 12:01 pm
Location: Central Victoria

Post by Patroler »

90Mav wrote:
they dont 'kick' in like a thermo fan

they pretty much do if they're working well!
Hmm. i have a brand new genuine fan on my TD42.. cant say iv'e ever noticet it in any way.. noise power ect...?
well i suppose it don't matter as long as it stays at the right temp, mine usually hovers between 1/4 - 1/3, and you'd only hear it if you were at a constant speed/rpm (highway) with the radio off and were listening for it! still definately hear it tho.
There are no stupid questions, but there are a LOT of inquisitive idiots
Posts: 239
Joined: Thu Aug 07, 2003 2:27 pm
Location: Mongol land

Post by GeneralFubashi »

replacement clutch is about $360. Dont believe anyone makes an aftermarket one either. Only about double the price of a genuine toyota model...
Posts: 14668
Joined: Mon Aug 29, 2005 7:10 pm
Location: western shitney

Post by j-top paj »

GeneralFubashi wrote:replacement clutch is about $360. Dont believe anyone makes an aftermarket one either. Only about double the price of a genuine toyota model...
its a nissan ;)

and there are plenty of aftermarket ones available as i have tried 4 of them :cry:
Banzy wrote:Dial up internet.........you'd post something and come back 2 beers later to see if it loaded.
my GU
Posts: 1698
Joined: Sun Nov 28, 2004 7:26 pm
Location: Canberra Australia

Post by Ezookiel »

DA DUDE wrote:well tell this is it because i'm running a diesel viscus fan in a petrol engine is their diffrent's

Well there's a heck of a difference between the diesel and the petrol fanblades themselves. The diesel fan has one extra blade, and a more aggressive angle.

When I went from the petrol one that some moron had put on the diesel troll before I bought it, to the Diesel one I put on it last week, The difference in airflow was massive. It also meant that with no other changes, I went from 60% of the gauge on a hill climb, to 50% of the gauge on a hill climb - from 70% on a long climb, to 60% on a long climb now. I am stoked with it.

It cost me $50 odd including postage from "Patrolapart" on ebay.
[url=http://www.4x4him.org]Bringing the Christian Rock Crawling Community a little closer[/url]
Posts: 227
Joined: Sat Dec 01, 2007 11:56 pm
Location: vic

Re: Viscus fan Vs Thermo fan

Post by gq351 »

[hey mate ,im running a 351 ford cleveland in a gq & i just recently pulled off the clutch fan & now running a twin thermo fan setup of a 1997 EL falcon,, it keeps it alot cooler, less noise & u notice a little power increase, & if it keeps a ford cool it should do yours easyly,, good luck mate,,
GQ patrol '454' Big Block Chevy 7''lift 37'' muddies & heaps more...
Posts: 2254
Joined: Tue Dec 10, 2002 5:09 pm
Location: Sydney

Post by jessie928 »

DA DUDE wrote:well tell this is it because i'm running a diesel viscus fan in a petrol engine is their diffrent's
if you have a diesel viscous clutch, this will be your problem.

you need to put a petrol one back on.
Jes
ATTACH BROKEN TOYOTA HERE--->
DUCATI <-----Worlds best warning label
Posts: 2775
Joined: Thu Apr 13, 2006 8:59 pm
Location: Melbourne

Post by GQ Bear »

I got a new one for petty from Don Kyatt's in Moorabbin, Vic for a little over $100 i think. Japanese part, same as Nissan use but without the 'genuine nissan parts' packaging.

Give them a try, they may be able to post one to you. Hobzee on this forum may be able to source one for you too.
[color=violet]G[/color][color=white]O[/color][color=yellow] S[/color][color=blue]T[/color][color=yellow]O[/color][color=white]R[/color][color=violet]M[/color]
Premiers 1999, 2007, 2009
Spoon 2010
Post Reply

Who is online

Users browsing this forum: No registered users and 74 guests