Notice: We request that you don't just set up a new account at this time if you are a previous user. If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
I was bored and thought I would remove the wiper arms on the cruiser and give them a coat of paint, all was going good until I was putting the passenger side arm back on and when tightening the nut that holds the arm down must have gone a bit hard and now it wont go tight enough. I tried thread tape but with no joy.
I only hope its just he nut that is stripped and a trip to the wreckers will solve the problem, if its the thread on the shaft on the motor I am not sure what to do, am I up for another motor or is the shaft bit replacable?
Damn nuts have to be some custom job too - typical
Nah I checked for that when I first striped it, the raer wipers have a standard nut. And to make matters worst I was going to try the washer under the nut idea but now the nut has rattled loose while driving and its gone :(
Off to the wreckers for me on the weekend i guess..
