Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
80 series sub tank not changing over
Moderators: toaddog, Elmo, DUDELUX
80 series sub tank not changing over
i have an 80 series and the sub tank is not changing over from the main tank what could be the cause and i have pulled the switch apart and it seems to be fine
R.I.P. Darryl "DAZZA" Mutch 02/08/1978 - 26/08/2012 aged 34 years ... You will be missed my little brother.
http://www.outerlimits4x4.com/viewtopic.php?f=16&t=39190&start=150
http://www.outerlimits4x4.com/viewtopic.php?f=16&t=39190&start=150
The changeover solenoids are located on the body just behind the cross member which is basically above the rear axle, and off centre to the left. There are two solenoids - one for forward fuel and the other for return.
Climb under there and feel for action on both solenoids as someone else activates the sub switch on/off/on/off.
They can physically jam from crap in the fuel or lack of use. Also electrical problems can occur - look for 12VDC on each solenoid when sub is selected.
There is a vulnerable wiring point where the cable exits the body floor pan just in front of the left hand rear wheel arch. It then heads straight toward the changeover solenoids. I have had stick damage bust a couple of wires there before.
Hope that helps.
Oh - and forget the hammer (in your sig)
Climb under there and feel for action on both solenoids as someone else activates the sub switch on/off/on/off.
They can physically jam from crap in the fuel or lack of use. Also electrical problems can occur - look for 12VDC on each solenoid when sub is selected.
There is a vulnerable wiring point where the cable exits the body floor pan just in front of the left hand rear wheel arch. It then heads straight toward the changeover solenoids. I have had stick damage bust a couple of wires there before.
Hope that helps.
Oh - and forget the hammer (in your sig)
Who is online
Users browsing this forum: No registered users and 0 guests