Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
blue smoke
Moderator: -Scott-
blue smoke
Ihave a nh 3.0lt which on start up blows blue smoke but in normal running does,nt blow any any suggestions .
There are tricks which allow the valve stem seals to be replaced without pulling the heads off - essentially, fill the cylinder with something to prevent the valves opening, and away you go.
It's the "fill the cylinder" bit which opens the door for the F*ck-Up Fairy. Some people advocate compressed air through the spark plug port - OK if you can keep the pressure up for as long as required.
Others feed in a length of rope, then turn the engine by hand to compress the rope between piston & valves. This is fine if the engine doesn't "turn back", and the rope doesn't leave anything nasty inside the cylinder.
There may be other methods of which I'm unaware, too. So, if you're reasonably competent with your hands, it can be done without pulling off the heads. If something goes wrong, the heads need to come off anyway. And you need to strip the engine so far that it's not much more effort to pull the heads off anyway. How's your timing belt/water pump?
It's the "fill the cylinder" bit which opens the door for the F*ck-Up Fairy. Some people advocate compressed air through the spark plug port - OK if you can keep the pressure up for as long as required.
Others feed in a length of rope, then turn the engine by hand to compress the rope between piston & valves. This is fine if the engine doesn't "turn back", and the rope doesn't leave anything nasty inside the cylinder.
There may be other methods of which I'm unaware, too. So, if you're reasonably competent with your hands, it can be done without pulling off the heads. If something goes wrong, the heads need to come off anyway. And you need to strip the engine so far that it's not much more effort to pull the heads off anyway. How's your timing belt/water pump?
Who is online
Users browsing this forum: No registered users and 14 guests