i ve got 84 hilux with a 2.4 diesel, the radiator was a seive so i threw it out. i would like to put a bigger radiator in so it runs a bit cooler, it would sit at about half, is that normal ?. i want it to run cooler because after i put it on the road, im going to supercharge it.
will a 2.8 radiator bolt strait in, and will the hoses line up? or is there another bolt in option?
bretty
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
lux radiators
Moderators: toaddog, Elmo, DUDELUX
Posts: 3523
Joined: Sun May 18, 2003 8:42 pm
Joined: Sun May 18, 2003 8:42 pm
Location: Somewhere they can't reach me, shoot me or electrocute me...
The 2.4 radiator is the largest you will find and is more than adequate to cool the motor - the cooling problem lies elsewhere. Get a standard 2.4 core in good condition from the boneyard (or a newie) and replace the viscous silicone fluid in the fan hub. Go to Toyota and buy 2 ampules of silicone fluid, crack open the fan hub, drain it thoroughly (but do not wash it with any type of degreaser) a hair dryer may help the old fluid to drain out, squeeze the new fluid in and reassemble. Get a fan shroud from the wreckers for your motor and radiator and your cooling problems will be solved, provided you have a clean (as in cooling/ water jacket) motor and it is not overfuelled to the max. If you are worried about actual temperature, buy a mechanical temp guage from supercheap. Remove the dash temp guage sender from the thermostat housing, and put it in the block drain plug hole (on the injector pump side of the block) place the new guage sender in the thermostat housing and you are set to accurately monitor temps.
Built, not bought.
Who is online
Users browsing this forum: No registered users and 2 guests