Wanted to know - with many wider tracked vehicles there is additional offset within the stub axle assemblies themselves - such as within the disc assembly itself.
Where exactly is the difference in width in the Narrowtrack versus widetrack - is it in the fact that the 1.3 has different front brakes or are the axles and the diffhousing itself actually longer by x amount and exactly how much wide are they both?
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
Where is the extra width in a widetrack?
The suspension mounting points are different as well.
On the narrow track the shackle end of the springs are mounted directly under the chassis, where the widetrack are mounted on the outside of the rails - still underneath, but an increase of about 50mm each side in width for the mounting points.
This might be the amount of extra width the diffs have, but I am not sure.
On the narrow track the shackle end of the springs are mounted directly under the chassis, where the widetrack are mounted on the outside of the rails - still underneath, but an increase of about 50mm each side in width for the mounting points.
This might be the amount of extra width the diffs have, but I am not sure.
From mesurements at a wreckers........(so be warned, I could be wrong...)
Difference in width between 'narrow track' and 'wide track' is 50mm from rim mounting face, to rim mounting face. The difference appears to be in the axles and housing (don't know if it is an even split/addition, ie don't know if the 'pumpkin' moves slightly or not.......understand?)
'Narrow track' diffs are not all the same. Width wise they are the same, but the centres and spline count are different between 1 litre and 1.3L.
Note: whilst I haven't personally done it (yet, been busy with little time for projects), I'm led to believe that LJ80 4.4 centres will go into the 1L diffs, replacing the front drum brakes with the 1.3L discs..............maybe Sam or somebody with experience in this field can tell me if I'm dreaming or not.....
Trust that will assist as a guide.........get ya tape measure, and go to a wreckers.
Difference in width between 'narrow track' and 'wide track' is 50mm from rim mounting face, to rim mounting face. The difference appears to be in the axles and housing (don't know if it is an even split/addition, ie don't know if the 'pumpkin' moves slightly or not.......understand?)
'Narrow track' diffs are not all the same. Width wise they are the same, but the centres and spline count are different between 1 litre and 1.3L.
Note: whilst I haven't personally done it (yet, been busy with little time for projects), I'm led to believe that LJ80 4.4 centres will go into the 1L diffs, replacing the front drum brakes with the 1.3L discs..............maybe Sam or somebody with experience in this field can tell me if I'm dreaming or not.....
Trust that will assist as a guide.........get ya tape measure, and go to a wreckers.
- Drewfus Designs -
"Build it small, DRIVE it big..."
"Build it small, DRIVE it big..."
Who is online
Users browsing this forum: No registered users and 44 guests