Notice: We request that you don't just set up a new account at this time if you are a previous user. If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
OK guys I know this is the wrong time to request a quick response but who wants to run out to their shed and measure the PCD of a NT drive shaft flange, any takers. I'll give you a big thankyou.
some conflicting info there, I have a transfer case that has been drill to suit NT but is not accurate. The 73 PCD I would say would be the one, WT is 85 PCD
if its a sierra transfer case , you dont have to drill anything after the 82 model as the flanges are interchangeable , if the flanges are original , you can usually tell from the old flange pattern and bolt hole sizes what the transfer case originally belonged to .
Cheers, I'm just trying to make my drive shaft spacers interchangeable between WT and NT, I know the PCD's are different but I have vary responces about the what is what, there must be three different flanges out there, so I assume the 1.0lt must be different again. but what is what
