Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

4.4 inlet manifold problems

Tech Talk for Rover owners.

Moderator: Micka

Post Reply
Posts: 59
Joined: Mon Sep 13, 2004 12:27 pm
Location: Melbourne

4.4 inlet manifold problems

Post by 80rangie »

Hi all,

I have taken the 500 Holley 2 barrell off my 4.4 and am replacing it with a Quadrajet that I had in the shed. Problem is I'm having big trouble trying to get the inlet manifold to seal.
The 2 barrell manifold sealed well on this motor and the 4barrell one seemed to seal well on the other motor, it may not have because the other motor only ran gas.

Anyone have any brilliant suggestions :?
Posts: 176
Joined: Sat Jun 16, 2007 8:18 am
Location: New Zealand

Post by bigbad »

what sort of trouble. Has the manifold or the heads/ block been skimmed at all?
Posts: 59
Joined: Mon Sep 13, 2004 12:27 pm
Location: Melbourne

Post by 80rangie »

The inlet manifold is sucking air and I don't seem to be able to seal it.
It is a P76 manifold that has had a 4 barrel adapter welded on in place of the standard carburettor mount.
I think maybe the heads/manifold have been shaved down because the manifold seems to sit lower in the valley. But judging by the marks on the gaskets it should be sealing.
Posts: 44
Joined: Tue Jan 25, 2005 5:26 pm
Location: Healesville

p76 Heads/ Manifold

Post by 360rangie »

If the manifold only has been shaved it wil sit lower in the valley, and if the heads have been shaved only the manfold will sit high in the valley. Both needed to have been shaved to compensate. The problem I think you might have is when the manifold was welded, being aluminium, it has warped. Usually the best thing to do when welding an aluminium manifold is do it while it is bolted to your block and heads that way it requires less machining if any. Have you tried placing two maniflod gaskets on each side. The only thing you have to be careful of is place some high temp sealant between the manifold and both gaskets. If al else fails, I'm sure someone on here or fleebay will have a four barrel inlet manifold for a 4.4.
Post Reply

Who is online

Users browsing this forum: No registered users and 0 guests