Notice: We request that you don't just set up a new account at this time if you are a previous user. If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
On my recently purchased GU series 1 I have replaced the rear lights with the newer type III lights, which have reverse and indicators on both sides.
I did this because the old lights were looking shit with scratches and filled with dust, and I reckon the newer lights look better.
Now I want to wire then up, has anyone done this? I would like to know if the factory loom supports this or will I have to feed my own wires from the indicators on the bumper.
When I did fit them I noticed that the old connector does not have the required pins but I am wondering how big-a-deal this is going to be.
I also snapped off the bottom lugs on both sides of the old lights!
Pretty sure most of the wiring is already there for you just need to connect it all up.
There is one wire that you will need to bring over from the other side.
Can't quite remember which one, it was some time ago I looked into doing this but don't have the GU any more.
My club
www.vfwdc.com My store
Everything 4WD
86 Camms Road Cranbourne
www.everything4wd.com.au
sales@everything4wd.com.au
Phone: 03 59955055
The left side worked perfectly, indicator, reverse and brakes.
On the right side, no reverse and the indicator and brake both go off together, dimly, when using the indicator. I am going to the wreckers to get the connectors off a GU III adn see what I can do.
