g'day got sa question about oil filter selection on a range rover 1990 3.9
it currently has a ryco z89a (see link)
http://www.rycofilters.com.au/catalogue ... /part/Z89A
or can i fit the larger z9 (see link)
http://www.rycofilters.com.au/catalogue ... er/part/Z9
there seems to be enough room and flow rates etc are the same and they fit on the 3.5
below is some figures from ryco
RIF-FA9 3/8 13 7 100 32 Z9
RIF-FA10 3/8 13 7 100 32 Z89A
PART NO INCH LPM BAR PSI MICRON PART NO
thanks again[/url]
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
oil filter selection
Moderator: Micka
Under extreme conditions of upward axle movement, the axle can clout a Z9. A Z89A is a short Z9.
The change from the 3.5 is that the 3.9 has a sandwich for the oil cooler behind the filter.
And before you say impossible, remember the bump stops can compress flat, and people on other forums have had it happen.
Regards Philip A
The change from the 3.5 is that the 3.9 has a sandwich for the oil cooler behind the filter.
And before you say impossible, remember the bump stops can compress flat, and people on other forums have had it happen.
Regards Philip A
Who is online
Users browsing this forum: No registered users and 0 guests