hey finally got me L28 runnin, but it will only run for bout 1-2 mins, then stalls as if no fuel? any ideas? carby? i need to have the choke out a bit to start it....
and spark plugs have some black shit on em... like carbon...
prob hasn been started for bout a year opr more
cheers
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
L28 probs... MQ
L28 probs... MQ
ours is not to ask why, but to do or die!
well if its been sitting that long your prob gonna have to give it a good service, new oils and plugs and leads id say, new fuel in the tank and put some fuel treatment in to try get the carby flowin better, maybe run it without the air filter get better flow till it warms up.
95 GQ td42
3"lift 33 claws
covered in mud
3"lift 33 claws
covered in mud
New fuel pump diaphragm, almost garuntee'd to be torn after sitting for so long. otherwise change your oil and rev the gut's outa it.
Hold your rev's at a couple of grand, cover the air intake until it nearly stall's then remove....repeat 3 or 4 time's. dump your old fuel and replace with new high octane stuff. also bad rotor button and cap contact's could be causing the fouling, clean these up first.
It's an L series motor and they can cop some serious abuse before failing.
Hold your rev's at a couple of grand, cover the air intake until it nearly stall's then remove....repeat 3 or 4 time's. dump your old fuel and replace with new high octane stuff. also bad rotor button and cap contact's could be causing the fouling, clean these up first.
It's an L series motor and they can cop some serious abuse before failing.
Who is online
Users browsing this forum: No registered users and 130 guests