Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

Bump Steer

Tech Talk for Nissan owners.

Moderators: toaddog, V8Patrol

Forum rules
Post Reply
Posts: 15
Joined: Thu Feb 21, 2008 12:45 pm
Location: Adelaide

Bump Steer

Post by JJ42 »

I have a GQ with a 4" lift 35s and seem it has seemed to have developed a bit of a bump steer problem that wasnt there when it was first lifted. Is there an ajustment to the seering box ( possible tigtning the steering ). Any suggestions??
Top
Posts: 1857
Joined: Fri Feb 02, 2007 12:16 am
Location: ipswich

Post by nastytroll »

king pin bearings, panhard bushes, best position for steer damper is steer arm to panhard, if your damper goes to your chassis move it to the panhard and it will feel much better
Top
Posts: 810
Joined: Thu Jul 15, 2004 8:02 am
Location: Somewhere in NSW

Post by brighty »

I too have this problem so will be looking at replacing all bushes in the not too distant future to see if this rectifies the problem.

Any other ideas too??? Just in case.
When in doubt..... UTE-ERIZE it!!!
Top
Posts: 15
Joined: Thu Feb 21, 2008 12:45 pm
Location: Adelaide

Re: Bump Steer

Post by JJ42 »

[quote="JJ42"]I have a GQ with a 4" lift 35s and seem it has seemed to have developed a bit of a bump steer problem that wasnt there when it was first lifted. Is there an ajustment to the seering box ( possible tigtning the steering ). Any suggestions??[/quote]

Are the swivel Hub Bearings hard to replace?
Top
Posts: 1857
Joined: Fri Feb 02, 2007 12:16 am
Location: ipswich

Post by nastytroll »

not hard just time consuming, it requires the housing be stripped right down also.

Best bet is buy a swivel hub kit from hobbzee http://stores.ebay.com.au/The4wdshop_Ni ... idZ2QQtZkm Its a good price and will have the bearings you need in it.

If your goin to strip the hubs might aswell rekit all the seals. The only bearings and seals not in it are the wheel bearings and seal.
Top
Post Reply

Return to “Nissan”

Who is online

Users browsing this forum: No registered users and 0 guests