Does anyone have the torque specs for RD28T headbolts please.
Thanx in advance Damo
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
torque specs PLEASE
torque specs PLEASE
have grinder will fit
www.4Bfabrications.com.au
www.4Bfabrications.com.au
From my gregorys manual so try and make sense of this.
Instal the cylinder head gasket and then instal the cylinder head, ensuring that it is in positioned correctly over the locating dowels.
Instal the cylinder head bolts and tighten them as follows:
a) following the tightening sequence, tighten all the cylinder head bolts, except the two M8 bolts to 29 Nm.
b) In the same sequence, tighten all the cylinder head bolts, except the two M8 to 113 Nm.
c) using the cylinder head bolt loosening sequence, loosen the cylinder head bolts completely.
d) Following the tightening sequence, tighten all of the cylinder head bolts, except the two M8 bolts to 29 Nm.
e) In the same sequence, tighten all the cylinder head bolts, except the two M8 bolts to 118-127 Nm.
f) Tighten the two M8 bolts to 16-21Nm.
****The two M8 bolts are the two short bolts on the drive side of the engine front and rear without the alan key head.
Instal the cylinder head gasket and then instal the cylinder head, ensuring that it is in positioned correctly over the locating dowels.
Instal the cylinder head bolts and tighten them as follows:
a) following the tightening sequence, tighten all the cylinder head bolts, except the two M8 bolts to 29 Nm.
b) In the same sequence, tighten all the cylinder head bolts, except the two M8 to 113 Nm.
c) using the cylinder head bolt loosening sequence, loosen the cylinder head bolts completely.
d) Following the tightening sequence, tighten all of the cylinder head bolts, except the two M8 bolts to 29 Nm.
e) In the same sequence, tighten all the cylinder head bolts, except the two M8 bolts to 118-127 Nm.
f) Tighten the two M8 bolts to 16-21Nm.
****The two M8 bolts are the two short bolts on the drive side of the engine front and rear without the alan key head.
GQ with big nuts
Who is online
Users browsing this forum: No registered users and 93 guests