Hey all,
have heard many conflicting rumours.. and i wanted to get it set straight.
Is it possible to fit 33" tyres on my standard NJ lwb rims?
THe standard rims are 15x7...
IS IT POSSIBLE??!?!
I am getting a 2inch body lift
and a rear 2inch spring lift
(cranking up torsion bars and sticking with stock suspension)
does this setup sound ok?
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
Fitting 33" to standard NJ wheels?!
Moderator: -Scott-
Yes - it's possible.
33" is the diameter of the tyre - what width are you planning to use?
33x10.5 shouldn't be a problem, but there's not many tyres available in that size.
33x12.5 is a common size, but too wide to be legal on 15x7 - I think 15x8.5 is the minimum recommended size (in Australia - other countries may differ.) Some people do run 33x12.5 on the factory rims, but you may struggle to find a tyre retailer who will mount them for you.
33" is the diameter of the tyre - what width are you planning to use?
33x10.5 shouldn't be a problem, but there's not many tyres available in that size.
33x12.5 is a common size, but too wide to be legal on 15x7 - I think 15x8.5 is the minimum recommended size (in Australia - other countries may differ.) Some people do run 33x12.5 on the factory rims, but you may struggle to find a tyre retailer who will mount them for you.
You're welcome.jester4x4 wrote:thanx for the info mate
I run 285/75-16 (approx. 33x11) on aftermarket Patrol fitment steel wheels. Currently STTs, might look at MTZs next time around.jester4x4 wrote:what tyres do u ride with?
Body lift is independent of suspension - suspension is only connected to the chassis.jester4x4 wrote:Oh btw - is it true that u dont hav to upgrade ur shocks if u get a body and spring lift? (2inch)?
Your front suspension travel is limited by upper and lower stops - adjusting the ride height only affects where the control arms "sit" normally, so total shock absorber travel isn't affected. If you start cutting stops (which many do) you run the risk of the shock absorber reaching the end of its travel - although late model Pajeros (Gen 3) don't have droop stops, and use the shock absorber to limit travel.
Rear travel is easier to increase, so that's where you may need longer shocks. I have Old Man Emu rear springs and shocks, but I don't know if the shocks are longer than factory. At maximum articulation (without sway bar) the shock absorbers bind on the control arms at about the same time the shocks reach max travel - so I'm not sure longer shocks would help (unless I relocate the upper mounts - I'm thinking about it...)
Who is online
Users browsing this forum: No registered users and 1 guest