Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

water and 60series

Tech Talk for Cruiser owners.

Moderators: toaddog, Elmo, DUDELUX

Forum rules
Post Reply
Posts: 238
Joined: Sun May 07, 2006 7:37 pm
Location: Pakenham

water and 60series

Post by seaeagle »

when i go through water in the 60 it has a fit, wont rev kepps stalling when i try to rev it, its 3f on gas with elect. ign. ive looked at the basic stuff but cant find what is causing it. could it be steam?
Top
Posts: 207
Joined: Thu Sep 20, 2007 4:37 pm
Location: victoria

Post by johno88 »

when you say basics what do you mean? is water getting in the dizzy and making it run on less cylinders?
Top
Posts: 238
Joined: Sun May 07, 2006 7:37 pm
Location: Pakenham

Post by seaeagle »

no water in dizzy. leads all good, it doesnt take long to come good , mabee about 5 mins, i did change it over to petrol and it ran good when i put it back to gas after 3-4kms it coughed and spluttered abit them was ok.
there is a join in the elect. ign. wires but its not looking like its getting wet.
Top
Posts: 147
Joined: Sat Aug 04, 2007 1:28 pm
Location: Sydney

Post by little rusty »

i had the same issues with my landrover disco V8. would show same symptoms but have absolutely no water iunder dizzy cap as far as I could see - actually looked bone dry. However, short spray with WD40 and a wipe out she started first go and has actually ran better!!!

give it a crack
Top
Post Reply

Return to “Cruiser / Prado”

Who is online

Users browsing this forum: No registered users and 2 guests