Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

Johhny Joint for Radius Arm End

General Tech Talk

Moderators: toaddog, TWISTY, V8Patrol, Moderators

Forum rules
Post Reply
Posts: 70
Joined: Fri Aug 27, 2004 11:58 pm
Location: South Africa

Contact:
Contact Freakazoid

Johhny Joint for Radius Arm End

Post by Freakazoid »

Hi Guys

Would a Johnny Joint handle the loads if used at the chassis end of a radius arm? I want to make new radius arms that attach behind and below the transmission crossmember on my GQ. They will end up about 1100mm from axle to chassis end. I was thinking of using a big johnny style joint at this end. I know the radial or push pull loads will be fine but what about sideways/axial loads? The ball on the joint will be about 2" and the OD of the joint, basically the ring on the raius arm will be just over 3".

Thanks
94 GQ, Air Suspension, 35's, Soon to have VH45
Top
Posts: 1676
Joined: Tue Oct 22, 2002 9:26 am
Location: brisbane

Post by 1MadEngineer »

try these guys!
http://evolutionmachine.com/

Image
WWW.TEAMDGR.COM
WWW.SUPERIORENGINEERING.COM.AU
WWW.LOCKTUP4X4.COM.AU
Top
Posts: 1676
Joined: Tue Oct 22, 2002 9:26 am
Location: brisbane

Post by 1MadEngineer »

i think these are more realistic!!

http://www.locktup4x4.com.au/product/66 ... cbe89.aspx

Image
WWW.TEAMDGR.COM
WWW.SUPERIORENGINEERING.COM.AU
WWW.LOCKTUP4X4.COM.AU
Top
Posts: 671
Joined: Mon Aug 23, 2004 10:06 am
Location: Mornington

Post by YankeeDave »

the johnny joint would be fine mate, go for it
Jeep Wrangler TJ

Jeep Cherokee XJ
Top
Posts: 70
Joined: Fri Aug 27, 2004 11:58 pm
Location: South Africa

Contact:
Contact Freakazoid

Post by Freakazoid »

Thanks guys, I also thought so but it doesn't hurt to ask. Will post as soon as it is done. The radius arm will be made out of 32mm thick 650MPa Roqtuf, very similar to your Bizalloy.

Thanks again.
94 GQ, Air Suspension, 35's, Soon to have VH45
Top
Post Reply

Return to “General Tech”

Who is online

Users browsing this forum: No registered users and 3 guests