G'day
i have a 91 sierra with the standard carby on it and it wont idle below 2000rpm, i checked all the vacum lines found one off, put it back on but that hasnt changed the idle, been fiddlin with the idle screw but that hasnt helped, the choke isnt stuck on as it doesnt work at all, and checked to see if intake gasket is broken but it appears to be fine. it isnt blowing black smoke either so im thinking its sucking air from some where...
Any ideas as to wat else it could be or wat else i should check?
Mundy
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
excesively high idle
excesively high idle
Last edited by mundy on Thu Aug 21, 2008 12:58 pm, edited 1 time in total.
check the head light idle up actuator at the front of the carby, they are renowned for packing it in. it is linked via an arm to the throttle shaft.
lwb 1.6efi,4sp auto,f&r airlockers,dual t/cases.custom coils.builder of ROAD LEGAL custom suzukis...and other stuff.
CAD modelling-TECH drawings-DXF preparation.
http://www.auszookers.com/index.php
CAD modelling-TECH drawings-DXF preparation.
http://www.auszookers.com/index.php
is the accelerator cable too tight , it may be adjusted too tight , check you have some freeplay in the cable where it links onto the throttle arm
when the car is warmed up , feel the 2 hoses that go to the top of the back of the carb , if they are cold , water isnt flowing through them to operate the wax pallette choke , the cold idle screw could be holding the revs up in that case .
when the engine is stopped , lift the throttle linkage (where the cable connects) and you will see a screw underneath , wind this out a couple of turns and then start the engine . does the revs decrease then ?
if that fixes the problem , you have to pull off the hoses and diagnose at what point the water isnt flowing to come off the cold idle setting .
hope this helps.
when the car is warmed up , feel the 2 hoses that go to the top of the back of the carb , if they are cold , water isnt flowing through them to operate the wax pallette choke , the cold idle screw could be holding the revs up in that case .
when the engine is stopped , lift the throttle linkage (where the cable connects) and you will see a screw underneath , wind this out a couple of turns and then start the engine . does the revs decrease then ?
if that fixes the problem , you have to pull off the hoses and diagnose at what point the water isnt flowing to come off the cold idle setting .
hope this helps.
Who is online
Users browsing this forum: No registered users and 48 guests