After reading the Forum Post on Nissan Diff specs, I was under the impression that my 96 Dual cab had an "HG43" diff combination, but I have now seen these parts and they look very different to mine.
I have checked the ratio (roughly) and it appears to be 4.8:1.
The Plate (the diff bit I think) nominates that it is CA48.
From my limited understanding, this would appear to tie in with the 4.8:1 ratio and would mean that the front diff would be an R180 front and C200 rear. (I also measured the outside of the rear cover and a 233mm crown wheel would definately not fit, but a 200mm crown wheel looks like it would fit.
Can anyone advise:
1) Are these assumptions correct; and
2) If that is the case could I put a different ratio from another nissan with the CA designation eg. CA41 - Found on 720's
Thanks in advance.
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
NAVARA D21 DIFFS
Who is online
Users browsing this forum: No registered users and 2 guests