OKay i just bought a Mq TD and the clutch engages just 1cm off the floor and its a bit annoying. Can they be adjusted in anyway to engage a little further up?? It doesnt seem to be slipping, did the ol 20kms an hour in fourth and foot to the floor and it didnt slip a bit, It doesnt seem to have any leaks and the slave cylinder doesnt seem more than a few years old..
Can they be adjusted..
Marc
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
Clutch adjustment on a Mq SD33t
Clutch adjustment on a Mq SD33t
Looking for a car
There is a slight adjustment on the bar that comes off the master cylinder and attaches to the pedal.
You need to remove the pin that attaches it to the petal and unscrew to make it longer.
Also check if the hole in the pedal where the pin goes though hasnt flogged out over time and become larger than the pin. If it has you will need to drill it out and put a bolt in it.
I would suggest thats ore than likely the issue.
Im in Ballajura NOR if you get stuck and need a hand.
You need to remove the pin that attaches it to the petal and unscrew to make it longer.
Also check if the hole in the pedal where the pin goes though hasnt flogged out over time and become larger than the pin. If it has you will need to drill it out and put a bolt in it.
I would suggest thats ore than likely the issue.
Im in Ballajura NOR if you get stuck and need a hand.
Who is online
Users browsing this forum: No registered users and 41 guests