Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

Clutch Flywheel Question??

General Tech Talk

Moderators: toaddog, TWISTY, V8Patrol, Moderators

Post Reply
Posts: 43
Joined: Tue Mar 13, 2007 9:49 am
Location: South Oz

Clutch Flywheel Question??

Post by gravel »

Gday,

I'm still trying to get to the bottom of this ticking noise in my Hilux that goes away when i depress the clutch.

Ive now been told that it could be the 'teeth' in the clutch slightly rubbing on the flywheel.

I have noticed that the ticking noise gets faster the faster i go and slows down as the vehicle slows.

So does the flywheel spin faster as you accelerate to a higher speed and then slow as the vehicle slows??

If so could this be the problem - i figure this makes sense that's all??

Any ideas would be great. ;)
Posts: 826
Joined: Mon Mar 20, 2006 1:08 pm
Location: Redcliffe

Post by berad »

yes the flywheel speeds up, but it speeds up with engine revs. and slows with the revs decreasing.

Pull the box off, whatever it is your most likely going to have to pull it off anyway.
Posts: 8556
Joined: Mon Jun 13, 2005 9:34 pm
Location: Sydney

Re: Clutch Flywheel Question??

Post by RockyF75 »

gravel wrote: I have noticed that the ticking noise gets faster the faster i go and slows down as the vehicle slows.

So does the flywheel spin faster as you accelerate to a higher speed and then slow as the vehicle slows??
The rate at which the flywheel spins is based on engine revs. So at 2000rpm doing 40k's it will be spinning at the same speed at 2000rpm at 100ks, for example.
60 + Turbo, 33"s :armsup:
Posts: 159
Joined: Sun Sep 17, 2006 12:23 am
Location: Tamworth, NSW

Post by ricky1970 »

Try a RS throwout or spigot bearing. Pull the box and have a look
Post Reply

Who is online

Users browsing this forum: No registered users and 0 guests