Notice: We request that you don't just set up a new account at this time if you are a previous user. If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
Disclamer: I just built this think from steel scrap. I have not looked up a table or designed it to be safe. you copy it at your own risk.
not too shabby for 5 hours work.
2500 high, 3200 wide. will span the whole buggy length ways and lift the driveline onto my fab bench / of chassis bench. I will be fabbing a retangular frame to fit at the midpoint of this frame and pivot 360 deg horizontally to allow me to tig without out of position welds. figure 8 hours building all this will save 100+ hours of akward welding.
time to commence the buggy build
ADHD Racing would like to thank Mrs Bru @ Sunshine Coast Developmental Physiotherapy - www.scdphysio.com.au , Ryano @ Fourbys www.generaltire.com.au Blitzkrieg Motorsport
I should add the top trolley contains 4 bearings with a 12mm bore running 3mm away from the edge of the rhs - just after the radius stops.
also the outriggers at the top are for the chassis table. I figure a ratchet strap at each end is as good a method as any - to rotate / lock the table.
cheers bru
ADHD Racing would like to thank Mrs Bru @ Sunshine Coast Developmental Physiotherapy - www.scdphysio.com.au , Ryano @ Fourbys www.generaltire.com.au Blitzkrieg Motorsport
