FITING LOCKRIGHT TO MQ FRONT ANY TIPS TO MAKE LIFE EASY
AS NEVER PLAYED WITH FRONT DIFF BEFORE
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
FITING LOCKRIGHT TO MQ FRONT
God of Magnificant Ideas!
God of Magnificant Ideas!
Oh yeah .... almost forgot.... a shortcut to save time...
take off the wheel,
then the locking hubs,
then the wheel bearings ( 65mm socket required for that )
remove the brake caliper & disk.
There are 6 bolts that hold the outer hub to the knuckle ( the disc brake protection plate is also held by them)
remove these 6 bolts and the outer hub,
This will then allow tha CV and drive shaft to come out,
saves having to remove the hub all together so the kingpins are left undisturbed as is the draglink.... 6 bolts verses 9 bolts and a whole heap of ugly grease !!!
You will not have to remove the pinion shaft, but if you are doing bearings aswell then make sure that you count the number of turns you undo the nut that holds it in place. When you reassemble it do up the nut EXACTLY the same number of turns..... if you dont then you run the risk of stuffing the "crush tube"..... nut size is a 27mm socket, to hold the drive shaft flange use a piece of plate with 2 holes drilled in it and just drop the driveshaft bolts in it to hold it
have fun and allow a saturday to do it in !!!
Kingy
another tip while ya in there...
FIT NEW BEARINGS AND SEALS !!
take off the wheel,
then the locking hubs,
then the wheel bearings ( 65mm socket required for that )
remove the brake caliper & disk.
There are 6 bolts that hold the outer hub to the knuckle ( the disc brake protection plate is also held by them)
remove these 6 bolts and the outer hub,
This will then allow tha CV and drive shaft to come out,
saves having to remove the hub all together so the kingpins are left undisturbed as is the draglink.... 6 bolts verses 9 bolts and a whole heap of ugly grease !!!
You will not have to remove the pinion shaft, but if you are doing bearings aswell then make sure that you count the number of turns you undo the nut that holds it in place. When you reassemble it do up the nut EXACTLY the same number of turns..... if you dont then you run the risk of stuffing the "crush tube"..... nut size is a 27mm socket, to hold the drive shaft flange use a piece of plate with 2 holes drilled in it and just drop the driveshaft bolts in it to hold it
have fun and allow a saturday to do it in !!!
Kingy
another tip while ya in there...
FIT NEW BEARINGS AND SEALS !!
[color=blue][size=150][b]And your cry-baby, whinyassed opinion would be.....? [/b][/size][/color]
Who is online
Users browsing this forum: No registered users and 4 guests