Is the spline on the rear axles the same through out the diff ratio's?
I have a diff and can't install the long side axle from a 4.6 diff. The end of the axles bottom's out on the centre and there is still about 12mm to go.
Short of cuttin the tip of the axle and re-machining the bearing taper, what can I do? I'm looking for a 4.3 axle just to test with.
Thinking that the Star gears on the 4.3 and 4.6 diffs are a different width.....
Any thought?
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
MQ Splines, Axles and sun gears
MQ Splines, Axles and sun gears
Buds Customs : Street, Track & Trail - Parts & Fabrication - Nissan, Toyota, Custom D60 gear
http://www.facebook.com/budscustoms
http://www.facebook.com/budscustoms
wicked
on the rear of the MQ MK's the axels touch each other in the center. Thus needing the correct shims behind the backing plate to set up the end float.
loosen up ur short axel retainer nuts pull it out a little and try putting in the long axel. If this helps get it in further there may be a spacer or somthing missing.. Cant remember whats in there..
Sterlo
on the rear of the MQ MK's the axels touch each other in the center. Thus needing the correct shims behind the backing plate to set up the end float.
loosen up ur short axel retainer nuts pull it out a little and try putting in the long axel. If this helps get it in further there may be a spacer or somthing missing.. Cant remember whats in there..
Sterlo
Who is online
Users browsing this forum: No registered users and 1 guest