what is the best way to put a winch on the rear of a gq wagon any photos
will be helpful thanks
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
what is the best way to mount a winch on the rear of my gq
Portable winch cradle would be the easyest.
You could have custom rear bar fabbed up to take a winch, this would however limit your departure angel.
Could make a custom fuel tank with a cut out to fit the winch in behind the chassis rail.
A mid mount winch with the cable coming out the back.
Its possible but will be a lot of work to make it look good and not limit other functions of the fourby.
You could have custom rear bar fabbed up to take a winch, this would however limit your departure angel.
Could make a custom fuel tank with a cut out to fit the winch in behind the chassis rail.
A mid mount winch with the cable coming out the back.
Its possible but will be a lot of work to make it look good and not limit other functions of the fourby.
Anything is possible, it just comes down to time and money.
Ferals build www.outerlimits4x4.com/ftopic164570.php
Ferals build www.outerlimits4x4.com/ftopic164570.php
mid mounted between the chassis rail. Body lift required and and possibly mods to the floor pan. If you won't be doing serious winch comps I wouldn't bother. Even comp trucks don't always run rear winch setups.
GU Patrol intercooled TD42T, lifted, Cheezy sliders, ARB air locker, beadlocked Claws, Warn winch
I have also seen a pulley that slot into the front winch, that hangs down below axle level. The front winch cable could be pulled run around the pulley and under the car thus enabling back ward winching.
Another option maybe not the best but it would work. Mount the winch in the back somewhere behind the passenger seats then open the rear doors when you want to use the winch. damaging the doors would be pretty easy however.
Another option maybe not the best but it would work. Mount the winch in the back somewhere behind the passenger seats then open the rear doors when you want to use the winch. damaging the doors would be pretty easy however.
Anything is possible, it just comes down to time and money.
Ferals build www.outerlimits4x4.com/ftopic164570.php
Ferals build www.outerlimits4x4.com/ftopic164570.php
You could mount a 9500lb Low mount across the front edge of the rear sping towers with some 5mm plate between them and some brecing on the front face then run a small fairlead between the body and rear step on the rear of the truck. thats were mine is going to go when i get aronud to it on my Tray back GQ. You just have to watch the clearince on the upper links as thay cycle and a 30mm body lift might help also
Hey cun7s,
Here's one that will go on the rear of the car. Just take plenty of beer to help power it.
http://www.arb.com.au/products/arb-reco ... d-winches/
Here's one that will go on the rear of the car. Just take plenty of beer to help power it.
http://www.arb.com.au/products/arb-reco ... d-winches/
Who is online
Users browsing this forum: No registered users and 0 guests