anyone know where or who could be of some help i need a bellhousing/conversion kit to get me on my way, any help will be greatly appreciated(marks adapters dont want a bar of it an dellow not doin anything at this stage).
cheers,
ash.
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
ford 5.4L into gu
Moderators: toaddog, TWISTY, V8Patrol, Moderators
ford 5.4
you will have to go to a cnc engineer to get it made up
and will cost at least $1500 dollars
just been through it on different motor
and will cost at least $1500 dollars
just been through it on different motor
As sideways said, you will prob need to get it done custom.
If you want to give it a go yourself, especially if you are any good at 3d modelling programs, is to precisely draw both surfaces where you would either bolt up a sandwich plate if possible using original bellhousing, or remove bellhousing and draw the surface which it bolts up to.
Then you have to line up those drawings at the right distance from each other for splines to mate, etc....
It would be a pretty hard task, especially matching splines n flywheels/flexplates, etc...
Also, a lot of engineers or similar places would have a special device which can map a 3d object on computer by (basically) using an arm and a pointer to map certain points on whatever object you want to draw (like bolt holes, outside diameters, etc... which the computer then models.
If you want to give it a go yourself, especially if you are any good at 3d modelling programs, is to precisely draw both surfaces where you would either bolt up a sandwich plate if possible using original bellhousing, or remove bellhousing and draw the surface which it bolts up to.
Then you have to line up those drawings at the right distance from each other for splines to mate, etc....
It would be a pretty hard task, especially matching splines n flywheels/flexplates, etc...
Also, a lot of engineers or similar places would have a special device which can map a 3d object on computer by (basically) using an arm and a pointer to map certain points on whatever object you want to draw (like bolt holes, outside diameters, etc... which the computer then models.
Who is online
Users browsing this forum: No registered users and 0 guests